- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If you don't see anything on the radio saying "auxiliary output" with a little earphone jack then you aren't Aux ready.
You might be able to go to a stereo shop and have them install an auxiliary output plug. They will pull the factory stereo out and splice/plug in an output wire that you can plug your iPod into.
You can access the bulb by going to the rear of the car and removing the internal side panels at the opposite side of each tail light. You should see the covering and the socket for the light which you need to remove to gain access to the bulb.
1) let engine cool down all the way
2) pull plug wires off plugs one at a time.
3) remove plugs with proper spark plug socket.
4) replace plug
5) replace wire
6) move to next one.
Open the back hatch and in the well of the hatch you'll see two big screw that hold the black trim that holds all the lights on the rear right side and the same for the left. Once you take of the whole console (it's a little tricky you'll have to pivot it like opening a car door for it to come off) inside back you'll see all the light socket pushed into the console. Turn and pull out for each socket and then you'll see each light bulb. from there just replace the bulb.
hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?
×