What type of Rim can I buy for cheap for my Volvo?

Did you switch the TPMS sensor from your original wheel ?

Yes the axel must be bent

maybe a piece of your rim

FACTORY SPARE TIRE IN TRUNK HAS LARGER RIM. THE RIM IS 2 INCH BIGGER IN DIAMETER TIRE HEIGHT AND RIM WILL GIVE CAR CORRECT WHEEL HEIGHT.IF YOU DONT HAVE FACTORY SPARE TIRE.YOU CAN BUY SAME SIZE RIM THAT YOU HAVE ON YOUR VAN AT SALVAGE YARD PUT USE TIRE ON RIM OR GO TO DEALERSHIP THEY CAN GET YOU A FACTORY SPARE TIRE.

put 1 lug nut on a few turns do not comletely tighten and hit tire on inside with a mini sledge hammer do not hit rim, if you have aluminum rims this happens because of the oxidation and gets stuck on the brake rotor

3 possible answers. 1 the rim is bent 2 . unbalanced tire 3. wheel bearing needs replacement

check to see if one of (or more) the rims is bent,go to a tire place they will check it for cheap,if there is a bent rim they might be able to bang it out,or you might have to buy a new rim! have you driven over any potholes lately? or hit a curb?

Hi,
If the rim is bent severely, it could cause wear on your tire. If you are unsure of the severity, you might take the vehicle to a tire shop and have the wheel checked on a rotating balance type machine.
Worse case scenario, replace the rim (I'd get one from a wrecking yard). If the hub cap asthetics bother you, the salvage yard may also have one of those.
Hope this helps... Good luck!

Hello!
My sister had a Swift and the rims were 6" wide. Hope that helps!


-KC GTO Dad

you need to jack it up and spin 1 tire at a time, use a run out guage on the tires and wheels.a high speed 60 to 65 mph is from wheel balance. low speed is a bent wheel or a bad tire. belt separation