Window does not come down after opening the door

Sounds like it wasn't installed properly.

BCM is bad or has no power.

NOTE:
Anytime the batteryterminal has been disconnected, please initialize the driver's door power windowand front passenger's door power windowafter reconnecting the batteryterminal.

With ignition switchin the "ON" position, do the following:

1. Push down and hold the driver's door power windowswitch to completely open the window.
2. Pull and hold up the driver's door power windowswitch until the window closes.

Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination.
3. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions.

At this time the power window switchfor the passenger's door windowshould be blinking.
4. Push down and hold the passenger's door power windowswitch to completely open the window.
5. Pull and hold up the passenger's door power windowswitch until the window closes.
Continue holding the switch for approximately one second until the switch changes
from blinking to a constant illumination.
6. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions.

Sounds like there is a problem with the master switch on the left front door

Remove the door trim and reattach the rod/ lever that has come out of the fitting of the latch.

There are f few ways. Bust the plastic handle off the outside . Make sure the door is not locked. If you can get inside the door this way and see a rod near the door handle. Push up and down [ usually down ] on this, door should open . OR Roll the window down. Pry up on the inner door panel by the rubber piece that clears your window. This piece should be able to pry up, enough to see the same rod I am talking about.Usually, these rods push down to open the door. #3 Roll up window, put a small wedge between the window and the door by the door handle. This should get the gap open enough to look down inside the door. Look for this same rod, near the door handle, and push down on it to open the door. replace Hope I was helpful please rate this solution

turn the key on and hold the window button in up position for ten seconds ,turn key off and then open door and close it , window should go up .

It is most likely a rod has fallen off inside the door. You may have to use a coat-hanger to read down inside and pull back on door latch to open it up.
Then after it is opened, remove screws on inner door panel, remove window/lock controls, take a big flat-head screwdriver and gently pry next to the plastic tabs holding on door panel. Remove door panel and put window back on track , and replace or reattach door handle rods.

I DON'T KNOW ABOUT THE WINDOW PROBLEM - SOUNDS LIKE A FUSE.


FOR THE DOOR OPENER GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.

PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.

HOPE THIS HELPS

The rear window has to be completely down in order to move the tailgate! You should be happy that your window is stuck up, unlike mine which is stuck all the way down! I have to completly take apart my tailgate!! If you want to try a trick to get the rear window down, my bronco has a rear window switch right next to the headlight knob, take the 2 purple wires on that window switch, and cross them, if your motor still works and if the wires are good, that should make the window go down!!! good luck, hope that helps!