Cars & Trucks Logo

Related Topics:

Question about Subaru Forester

1 Answer

How do I reset the computer on my subaru forester 2004

As I could not find a fuse for the window switch in the drivers door I pulled out every fuse one after the other to check but none was blown. Getting back into the car I learned that I had no a/c, inside light, clock, radio and others. I am assuming that I upset the computer and wonder how I can get that reset. any clues???? Juergen Australia

Posted by Anonymous on

1 Answer

Pearson Ashby

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers

Hi to reset computer just unhook the battery leads for an hour or so, Also check your fuses again, this time with a tester. Sometimes the break in the fuse wire is so small you miss it. Also you may have a loose connection(fuse not pushes all the way in). Check your relay switches in the black box in the engine bay as well as the fuses in the same box. Hope this helps.

Posted on Nov 02, 2017

5 Related Answers

Anonymous

  • 4 Answers

SOURCE: 1996 Nissan Maxima Clock, Dome Light & Radio went out not working

you need to check the fuse some ?

Posted on Apr 02, 2009

Anonymous

  • 23 Answers

SOURCE: 2003 subaru forester clock stopped lighting.

Go to www.subaruforester,org and do a search for clock. This is a chronic problem but if you're handy with a soldering gun you can fix it yourself.

Posted on May 02, 2009

raptorelixer

  • 3 Answers

SOURCE: Power windows inop

a brake in ur wires in the door,on a 04 grand i had the same problem,in the wire harness were the junction box is rust had broken one of the male prongs

Posted on May 05, 2009

motor1258

Mike Butler

  • 6674 Answers

SOURCE: 2004 subaru forester, 99,000 miles. Check engine

Drop in to an Autozone, or Pep Boys, or similar big parts store & they will usually scan for codes free. This will hopefully eliminate all the guess work, or at least point everyone in right direction for better diagnosis. If not obvious from codes what the problem is, get back to us and we'll help you out.

Posted on Aug 23, 2009

Testimonial: "Thanks for the great suggestion . I'll have Autozone read the codes on Monday. Thanks again!"

satitus

steve titus

  • 277 Answers

SOURCE: my clock light on my 2004 Subaru Forester won't

Is this for a 1999 Forester or for a 2004 forester, the title lists both years. If it is a 1999 model then the problem most likely resides within the clock itself. Unfortunately, many clocks of this vintage go bad over time. I offer a reasonable repair service and many clock removal instruction sheets at www.autoclockrepair.com
I'd be happy to assist.

Posted on Mar 16, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

2004 forester dome light has no power

https://fuse-box.info/subaru/subaru-forester-sg-2003-2008-fuses
03 and 05 have fuse in different place not sure which one applies to you. Above is 03 and 05 fuse box diagram.
The dome light comes on when you open car door. I have had cars where the door switch was bad and would not turn light on. If your dome light has a switch on the dome light then you should have power to switch. If not and the fuses are good then it seems it would have to be a problem with wires or switches.
0helpful
2answers

Left passenger window down in rain and now it wont go up. 2004 Subaru Forester

Same thing happened to 2002 Suburban and it turned out to be the cables which are connected the window regulator (motor), assuming you have power windows. You will need to remove the panel on the passenger side door to determine the cause. It could be one of three things, the cables, the regulator, or a broken fuse or wire stopping the electrical current...this is pretty rare especially if this is the only window which is not operating.
0helpful
1answer

Wires pulled out of plug dont no place of wires in plug 2004 subaru forester on power window switch driverside

going to have to do the trial and error thing for the power window. connect them, try the window, if its wired backwards reverse connection. sorry can't be more help. if you have access to a wiring diagram, that would be your only other way to go

good luck

4helpful
1answer

Driver door on a subaru forester 2003. window will not go up or down. window is still in the track and the motor is still working

Could be a bad regulator or a bad guide rail pinning the window

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you should be able to see what's restricting the window from moving
2helpful
1answer

Driver's side window will not open or close automaticaly. Has to be pulled up and down by hand

Check the wiring and connectors supplying the driver-side window motor and also the fuses in case each window is fused seperately. The electric motor may have failed. When you operate the switch do you hear the motor working?
0helpful
1answer

Window stuck - 1998 Forester Limited

I installed speakers in my door panels.
Pop up the window controlls unplug switches,
remove plastic screw hiders to expose phillips screws
remove screw from door latch lever
pull out on door panel, then lift up
its not too hard good luck
[email protected]
3helpful
1answer

My 2003 Forester driver side window wont work.

You need power window regulator as the cable of the regulator is out its place ,

  1. Remove the gusset cover.
  2. Pull up the inner door handle cover toward you to remove the upper hook. Pull down it to remove the lower hook. Remove the inner door handle cover.
  3. Remove the power window switch assembly.
  4. Using a trim panel remover, remove the clips of the trim panel.
  5. Remove the speaker.
  6. Using a spatula, remove the door sealer.
  7. Remove the outer mirror assembly.
  8. Remove the front end of the door weatherstrip and gusset.
  9. Remove the stabilizers.
  10. Remove the rear end of the door weatherstrip (inner and outer).
  11. Operate the power windows switch so the bolts from the regular assembly are visible through the service holes. Remove the mounting nuts.
  12. Take out the door glass. CAUTIONDo not turn the regulator in closing direction after removal of the glass. Otherwise gear may be disengaged.
  13. Loosen the nuts to remove the rear sash.
  14. Disconnect the power window motor wiring harness.
  15. Loosen the four bolts and two nuts to pull out the regulator assembly.
  16. Remove the screws to remove the motor from the regulator assembly.
  17. Installation is the reverse order of removal.0759a6d.jpg23cb1e4.jpg

Good luck...

Not finding what you are looking for?

534 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22509 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

253 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...