Question about 2005 Buick LaCrosse

1 Answer

How to fix toe out problem with rear tires on 2005 Buick Lacrosse

Posted by Mark Sandhurst on

Ad

1 Answer

Anonymous

An Alignment shop can adjust it,

There is a rear suspension offset toe link
bolt avail for around $ 12.00 ea

Google--- 2005 buick lacrosse rear toe out adjustment

Posted on Dec 05, 2012

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: how do you add power steering fluid. 2005 buick lacrosse

It is very hard to see, its back and underneath the altenator, use a flashlight to find it buried under wires and tubes.

Posted on May 03, 2009

Ad

Robert Bivins

  • 192 Answers

SOURCE: lowbeams headlamp won,t work on 2005 buick

Start simple. Investigate your fuses, since it is unlikely, but not unheard of, for both low beams to fail simultaneously.

Do you know where your fuses are?

Posted on Aug 17, 2009

Anonymous

  • 3 Answers

SOURCE: how to install/change complete headlight assembly

Buick Lacrosse - The bright light fitting is the same as the dim so take it apart first to see how the cover screws off/on and the light comes out. Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. If not, then you need to release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. To remove these locking pins, pull or pry up the little tab in the center of the pin just like you were pulling a nail by the head. That should give you more space.

Posted on Apr 03, 2010

kapishtech

raj somaiya

  • 2272 Answers

SOURCE: Replace headight assembly on 2005 buick lacrosse

The procedure to replace head light assembly on buick lacrosse is as follows:--- 1)To remove and replace the headlight assembly you will need to remove 1 retaining bolt on the top of the headlamp assembly and 2 sliding retainers at the rear. 2) The carefully Pull up the retainers and that will release the headlight assembly and allow you to pull it out the front. 3) When installing the new headlight assembly make sure you have it lined up correctly before trying to install the retainers, don't force them it may get cracked . 4) Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. 5) Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. 6) On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. 7) Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. 8) Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. Note:-- The turn signal is part of the headlight assembly on your 2005 Buick LaCross. 9) To replace the headlight bulb you need to remove the front bumper cover. 10)To release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. 11)To remove these locking pins, pull or pry up the little tab in the center of the pin. Thanks.

Posted on May 23, 2010

Anonymous

  • 110 Answers

SOURCE: replace thermostat on 2005 buick lacrosse

hello there:
to replace the thermostat you will need to fallow the upper radiator hose back to the intake you should find two bolts holding the thermostat housing remove the bolts and you should find the thermostat under the housing you will need to remove the hose this will help you out and before in stalling clean gasket surface on both sides..... please leave a review thanks sincerely D.Jones

Posted on Jun 05, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Buick Lacrosse Rear Lugnut Torque Specs


most cars this is in the operators guide(glovebox) lost?
sure.
bet one at Buick. free.
3rd google hit.
and
http://www.vadengmpp.com/owners-manual/buick/2005-Buick-Lacrosse.pdf

page 5-92

nor more guessing its there. always was...

Jul 19, 2014 | Cars & Trucks

1 Answer

The left rear wheel on my 2005 Buick Lacrosse is not parallel to the right rear wheel. I would greatly appreciate any suggestions about this problem. Thank you in advance for having read my message!


Hi Michael, make sure the vehicle has not been involved in an accident. If the vehicle is sound have the suspension bushes inspected and the rear mountings checked. If there is a drumming noise from the rear it will most likely be from worn bushings. Regards John

Jul 21, 2012 | 2005 Buick LaCrosse

1 Answer

Does my 2005 buick lacrosse have remote start


Hello! There is a Service Parts Identification sticker located either in the glove box or near the spare tire with a list of three alphanumeric codes...If the sticker has "AP3" that means your Buick has remote start...

Guru...saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Apr 30, 2012 | 2005 Buick LaCrosse

2 Answers

Find fuel filter 2005 buick lacrosse 3.8



  • Under the car, drivers side rail, by the back tire. Make sure to remove the gas cap and release the fuel pressure from the nipple under the hood as well before starting this job. Not a hard job though. I think this filter is remove by wrench.



  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.


Regards, Tony

Oct 08, 2011 | 2005 Buick LaCrosse

1 Answer

Where is the buick lacrosse 2005, steer power reservior located?


passenger side of engine compartment roughly and to the rear of the P/S pump, black plastic reservoir with cap about the about 1" in diameter which is marked "power steering fluid"

Oct 08, 2010 | 2005 Buick LaCrosse

1 Answer

20 inch rims on 2005 buick lacrosse rubbing in rear


Call Frank at PDK Wheels and he can help you
see their hours at PDKWHEELS.COM

Apr 07, 2010 | 2005 Buick LaCrosse

Not finding what you are looking for?
2005 Buick LaCrosse Logo

Related Topics:

444 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...