Question about Honda Legend
Hi i have a honda legend and well the bluddy thing wont start i put the key in and the car beeps and all dash lights just flash take key out and lights stop flashing but car carrys on beeping started hen car was up on jack and missus tryed to turn the car on beeping started and car wont start please help
SOURCE: 2002 Monte Carlo wont start
sounds like your passlock sensor on the ignition barrel is faulty. you will have to go to the dealer to have it replaced because of the programming after replacement.
Posted on Nov 07, 2008
Yes the key needs to be reprogramed to the car. Unfortunately that will have to be done by the dealer. Make sure that you have plenty of proof that you are the owner. They will reprogram it but you will not take posession of the car until you prove it is yours.
Posted on Jan 04, 2009
SOURCE: 2000 dodge intrepid won't start
If the key is returning to the 'Run' position as it should, then either a relay controlling the solenoid or the solenoid itself is hanging up. The heavy contacts that send power to the starter can develop rough surfaces that can temporarily weld themselves together causing the starter to run on even though the engine is running and the key has returned to the proper position. There is also a spring that should normally help return the solenoid's contacts to their 'off' position that may be weakened.
Posted on Feb 07, 2009
the battery says 12 volts but may be dropping to 4 or 5 under a load...i would suggest jumpstarting the car and see what happens.the battery should read in the high 12 volts and not less than 9.5 under cranking. the dash lights go out on your car when starting,and the alarm will go off ,and disable the ignition if the voltage is too low in cranking the car because the computer will shut it down and activate the anti theft.....check your battery posts are tight. best of luck
Posted on Jul 22, 2009
Tips for a great answer:
Feb 12, 2015 | Honda Cars & Trucks
Mar 05, 2010 | 2004 Honda Civic
Feb 10, 2009 | 1997 Honda Accord
176 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: