1998 Dodge Dakota Logo

Related Topics:

Anonymous Posted on Nov 12, 2012

After shifting 1st to 2nd slips after 1min untill it want move forward turn off wait 2 min shifts fine 1 st to 2nd 1 min slips untill wont move can repete many time same thing

3.8 l driving it when happened had to start stop 1mile from home made it and will drive fine for 2 min then start again slipping

  • Anonymous Nov 13, 2012

    Changing Trans Fluid will only give you new fluid,won't fix a thing. Most likely need to rebuild it. Could try cleaning the valve body & then work on diagnosing the solenoids if problem continues

×

1 Answer

Jamie Alton

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Master 1,007 Answers
  • Posted on Nov 12, 2012
Jamie Alton
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Oct 30, 2012
Answers
1007
Questions
0
Helped
273036
Points
2955

Change gearbox oil and filter.

Retry.

5 Related Answers

Carlos Rojas

  • 119 Answers
  • Posted on Aug 08, 2008

SOURCE: my 99 dodge stratus shift

One or both of the speed sensors on transmission are bad. One is an input sensor, the other is the output sensor. If either one of these shows an open circuit (which they do when they go bad), then the transmission goes into Limp-Home mode and stays in 2nd gear. Those sensors are cheap enough where you should just go ahead and change both of them.

Ad

Anonymous

  • 1 Answer
  • Posted on Apr 28, 2009

SOURCE: Transmission won't shift from 1st to 2nd gear on it's own

Have someone scan the transmission for bad shift sensors.

Anonymous

  • 109 Answers
  • Posted on Aug 03, 2009

SOURCE: 1998 Dodge RAM 1500 won't upshift, slips out of gear

have you dropped the pan to see whats the bands are set at, any debris in pan bottom, whats your governor pressure, if bands are ok, but gov pressures are not relative to speed 1 psi per mph up to 95-127psi, port is on pass side of case rear top right, scan tool would be very helpful, your must have mil light on for this problem, gov dtc's, replace gov transducer as gov solniod as a pair, no exceptions, also are there any 02 sensor dtc's, shorted to voltage, this wil make pcm do stupid things to trans shift, affecting gov signals. GOOD LUCK RDJRP

Anonymous

  • 1 Answer
  • Posted on Aug 23, 2009

SOURCE: WHEN YOU PUT THE CAR IN DRIVE IT WILL NOT GO ANYWHERE

Its the electronic shift control located just under the battery ontop the transmission replace or repair will solve the issue

it'll go into drive but once it reaches 1500 rpm it'll drop into neutral as a safety because at this rpm it is being told to shift gear and when it fails to do so it safely goes into neutral

it will go into reverse just fine and park and you can run all the low drive gears until you reach 1500 rpm then it'll cut it off

i pulled mine out re soldered bad components on the board to fix it but im an electronics engineer it may be easier for you to just replace it

Testimonial: "I will try this as you suggested. Thanks for all your help."

Anonymous

  • 2317 Answers
  • Posted on Mar 07, 2010

SOURCE: 1998 Dodge Grand Caravan will not shif into 2nd

Most likely the second gear section of the transmission has gone bad. There are 3 or 4 different gear sections or assemblies in an automatic transmission, when they go bad, they go bad.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2001 Chevy S10 4x4 4L60E transmission works perfectly until 50MPH then I lose 3rd and 4th gear, 1st, 2nd and reverse are normal. Never happenend before, been parked since. Fluid is clean. Any ideas?

Are there any DTC's - diagnostic trouble codes ?in the PCM / BCM ? You have third an fourth below 50 mph but above 50 it down shifts to 2nd gear ,is this what your saying or you don't have 3rd or 4th gears at all ? Which engine did yours come with ? 2.2 L or 4.3 L You trans can set several DTC'S an not all will turn on the check engine light .
DTC B2722 (4.3 L) DTC P0218 (2.2 L) DTC P0218 (4.3 L) DTC P0502 (2.2 L) DTC P0502 (4.3 L) DTC P0503 (2.2 L) DTC P0503 (4.3 L) DTC P0705 (2.2 L) DTC P0706 (4.3 L) DTC P0711 (2.2 L) DTC P0711 (4.3 L) DTC P0712 (2.2 L) DTC P0712 (4.3 L) DTC P0713 (2.2 L) DTC P0713 (4.3 L) DTC P0719 (2.2 L) DTC P0719 (4.3 L) DTC P0724 (2.2 L) DTC P0724 (4.3 L) DTC P0740 (2.2 L) DTC P0740 (4.3 L) DTC P0741 (4.3 L) DTC P0742 (2.2 L) DTC P0742 (4.3 L) DTC P0748 (2.2 L) DTC P0748 (4.3 L) DTC P0751 (2.2 L) DTC P0751 (4.3 L) DTC P0752 (4.3 L) DTC P0753 (2.2 L) DTC P0753 (4.3 L) DTC P0756 (2.2 L) DTC P0756 (4.3 L) DTC P0757 (4.3 L) DTC P0758 (2.2 L) DTC P0758 (4.3 L) DTC P0785 (2.2 L) DTC P0785 (4.3 L) DTC P1810 (2.2 L) DTC P1810 (4.3 L) DTC P1860 (2.2 L) DTC P1860 (4.3 L) DTC P1870 (2.2 L) DTC P1870 (4.3 L) DTC P1875 (4.3 L) .
Shift Pattern This category contains the following topics:
?€¢
One forward gear only


?€¢
Two forward gears only


?€¢
Gear missing or slipping


?€¢
No upshift or slipping upshift


?€¢
No downshifts


?€¢
Non-First gear start


?€¢
Refer to First Gear Range Only - No Upshift .


?€¢
Refer to Third Gear Only .


?€¢
Refer to Second/Third Gear Only or First/Fourth Gears Only .


?€¢
Refer to Slips in First Gear .


?€¢
Refer to Slipping or Harsh 1-2 Shift .


?€¢
Refer to No 2-3 Shift or 2-3 Shift Slips, Rough or Hunting .


?€¢
Refer to No 3-4 Shift, Slips or Rough 3-4 Shift .


?€¢
Refer to No Part Throttle or Delayed Downshifts .


?€¢
Refer to Second Gear Start .

0helpful
1answer

What could my problem transmission only moves when I shift it through 1st,2nd, and 3rd

Valve body. You have a sticking valve. When you manually shift it into first, you force the sticking valve to move(pressure). There could be a couple other problems, But they are still in the valve body.
0helpful
1answer

Transmission slipping in 2nd gear

1 Ck A/T fluid level & quality
2 Scan/ck for code(s)
3 With scan tool connected,road test vehicle/Ck parameters....
....time for a pro !!

If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

1helpful
1answer

Does the generic electric module control shifting the transmission on a 1999 Ford Explorer?

ANY Slipping your done,internally worn out

The slipping overheats the clutches,how did
that get by you?
0helpful
1answer

Jeep grand cherokee slips in 2nd then wont down shif once in 4th

cel means nana, scan it.

ok , as with all a/t
1: CHECK FUSEs.
2: Check levels, ATF
3: do the full flush and filter and pray magic. (i have no hope)
4: the more you slip it the more damage to those clutch packs.
diagnose slip, that is a big show stopper.
see thje on car tests for this A/T here.

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

0helpful
1answer

Wont shift since ran out of gas

jeep ZJ 94.
no car runs, out of gas,,,, my dream do to this , has failed, 100 times.
HHO failed, and x,z,y.
even the match book cover, showing "turn water to fuel" fails.
im pulling your leg,

running out of fuel , likes to burn up fuel pumps.
they are fuel cooled and fuel lubricated. so dont do that. or $$$$$$$
after you ran it dry, the pump can fail, or have hard time priming.
long cranking to get the full system primed.
is engine running ok?, you failed to say that important fact...so.....
if engines ok?
does car go fast in 1st gear, fact 2 missing.....so...........???
wont shift can mean , tranny slips or wont go to 2nd, 3rd gear.???
which is it? slips? so skips?
or shifts late?
or shift too early.?

id reset the tranny TCM. (brain)

one way is to pull the battery neg cable for 5 min.
wait and put it back
all TCM have learn mode. so drive and teach it how you drive.
newer cars , 1trans, fists vast number of cars so it has an
even harder learn mode (not yours)

tell more get more......????????????????

the FSM is here.
under ZJ.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service
0helpful
1answer

91 jeep cherokee trany slips

Your done once it slips

Have to rebuild or replace
0helpful
1answer

1993 4l60e - Shifts hard on the 1-2 shift, works fine otherwise.

Did you change the transmission filter and gasket as well as the transmission oil before running your truck.
0helpful
1answer

Transmission shifting problems

If Drive Selector switch is properly aligned then a shift silonoid might be the problem.
Not finding what you are looking for?

218 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...