Question about 2006 Hyundai Tucson

1 Answer

My car (Hyundai Tucson 2 ltr 2006 model with G4GC-enjin) had a timing belt that snapped. We got a mechanic to replace the valves and fit everything again. New cylinderhead gasket and belt was also put on. When he started the car at first, it did run, but then it cut out. Now only cranking with no spark. We have enough fuel in car and the battery is fully charged. please help, car is already costing us a fortune.

Posted by Anonymous on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Hyundai Master
  • 12,962 Answers

Where is the mechanic that did the repairs? Check the wiring for the cam sensor?

Posted on Jul 20, 2017


5 Related Answers


  • 1 Answer

SOURCE: Hyundai Accent 1996/7 1500

I waited for about 30-60 minutes and cranked the car again and it started....first time. Why? Still don't know!!

Posted on Jul 21, 2008



  • 2 Answers

SOURCE: sonata starting problem

I had the same problem. Check coolant tenperature sensor. It gives cold signal to engin, even hot temperature and pump up too much gas. When you open the engin hood, it is located at right side. Just follow the radiator hose about 50cm and you can find small yellow metal bolt like.
It cost you $45 CD at dealer, but on internet market you can get under $20. Very easy to change. Put some sealant to avoid leaking coolant. Good luck!

Posted on Dec 14, 2008


  • 2 Answers

SOURCE: hyundai coupe wont start

did you change your plugs and wires?

Posted on Feb 27, 2009


Philip Long

  • 1486 Answers

SOURCE: 2003 hyundai xg350. Starts and runs, then cuts off.

Ita an imobilizer fault.Try changing the key fob battery first.Before having it reprogamed.

Posted on Jul 07, 2009


  • 23 Answers

SOURCE: I have a 2002 hyundai

if jump time that should be it timing marks and the tensioner are to lined up an also install new tensioner and recommend water pump if driven by the timing belt. if it has bent valves cause you jump time usually the car won't trun over at all.

Posted on Nov 04, 2009

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Watrpump replacment

the water pump is located on the side of the engine block where the cam belt is .its a straightforward job but again its a physically hard job as the cam belt and auxiliary belt need to be removed .and you will loose all your coolant .then the timing will need to be set up .when your car is due for a cam belt { its always worth replacing the water pump on any car }as its such a pain trying to change the pump again ..if you are thinking of doing this yourself ..I would think again is beyond the scope of a DIY mechanic from the point of view you will nned a ramp and even if you a good home mechanic I doubt that you will have a 2 post ramp!

Sep 04, 2013 | 2006 Hyundai Tucson

1 Answer

Timing belt broke 2005 hyundai tucson. New belt & tensioner& water pump Compression check shows no compression # 2 & # 6. Is it worth it to rebuild top end ?

I would say so, most probably the valves have been bent by hitting the pistons when the belt broke. When the belt breaks, the valves stop mmoving, and the pistons keep moving and will hit the valves and damage them.

Mar 21, 2013 | 2005 Hyundai Tucson

1 Answer

2006 hyundai tuscon serpentine belt issues

There may be a diagram under the bonnet, if not do a google search & you will find a diagram

Jun 01, 2012 | 2006 Hyundai Tucson

1 Answer

Does one have to change the timing belt of a Hyundai tuscon 2006 model. I

Scheduled Maintenance Services, for most Cars, has to be done at 30K, 60K, and 90K. Hyundai dealer recommend to replace the timing belt at 60K Service.
If you wait, one of two things could happen: Nothing, or the belt could break and you would be out thousands to repair the engine instead of a $400 hundred to replace just the belt. If it breaks, there will be damage done to the valves and various other internal components, which will not covered under warranty. The problem is that the Dealer would charge you between $700-$800 because they would also replace the water pump at the same time. Or you can buy the timing belt and change it by your self. To do so, you nee the Haynes Repair Manual specific for your car another equivalent.
2006 HYUNDAI TUCSON GLS 2.7L 2656cc V6 FI (D) DOHC : Engine : Timing Belt


Oct 29, 2010 | Hyundai Tucson Cars & Trucks

1 Answer

Chirping sounds on start up

Which engine?.. the 2.7 or the 2.0? Based on the description you give, it's probably a drive belt (on the 2.0). On the 2.7, there's only one belt.

Oct 15, 2009 | 2006 Hyundai Tucson

1 Answer

How often do I have to change the timing belt

On the 2L (4 cylinder) engine it is recommended to inspect the belt at 37200 miles and replace the belt at 56000 miles.

On the 2.7L (V6) it is recommended to replace the belt at 60000 miles.

And, both these engines are interference engines (meaning if they break a belt, pistons hit and bend valves) which is not a pretty sight...

Jul 28, 2008 | 2006 Hyundai Tucson

Not finding what you are looking for?
2006 Hyundai Tucson Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides