Change license plate light
Here is an article on switching over to the LED bulbs, but it shows you what must be done to access the lic plate bulbs as well.
SOURCE: Dashboard Lights
there is light bulbs behind the instument cluster. You will have to remove the screws, than pry off your panel and change the bulb.
SOURCE: tail lights and reverse lights out.
Check the bulbs for the tail/brake lights. If you put in single filament bulbs it will be on from the tail light voltage and the brakes will not show.
Try this;
Turn off the lights, press the brake pedal. Look at the brightness of the brake lights.
Now turn on the lights. Look at the brightness of the lights. If is the same as before the bulbs are wrong. You need two filament bulb.
SOURCE: Replace license plate lights
Hi there,
Firstly, remove the four screws on the bottom of the license plate light assembly using a Phillips screwdriver. Then pull the license plate light cover out away from the rear of the car. Pull the bulb forward and pull it straight out of the wiring socket.
A press the new bulb into place until it is secure. Push the bulb and wiring assembly back up inside the light assembly and replace the license plate light cover. Replace the four screws that secure the light cover and tighten them with a Phillips screwdriver. Finally, turn on the lights to test the new bulb.
Hope this helps...
SOURCE: 2002 license plate bulbs
its real simple look at the license plates then look up you will see 2 screw per lamp / unscrew them and slide remove its a 194 bulb so get some ready then replace and put back / Please rate my response thank you very much
SOURCE: I have a 2004 Toyota
You have to remove the rear door inside panel.First thing is to remove the top and side interior trim panels,they just pop out by prying them away after they are out the metal retaining clips sometimes stay in the door,pull them out and put them on the plastic panel before reinstalling.Then the strap that you use to close it has a cover on it that you have to push up to get off then remove the 10 mm bolt that holds the strap.Then pry the panel away from the door I think that the bottom has two hooks on it which means that the top needs come off first so you can lift the panel hooks out of the slots.Once the panel is off you will see the bulbs they twist out and you have to pull the bulbs out.Good luck
1,846 views
Usually answered in minutes!
×