Check the positive wire from coil, see if there is spark, or try to get some wire put it into positive battery and the one end into positive of coil, then try to start again and if there is spark now, dont try dis if your car have computer box.
i tested ign.module,bal.res.,jump wire from bat. to pos.side coil,replaced pickup module,coil,i get one spark when shutting off key from on to off?
u did a jumping wire try to draw the high tension wire from coil then try to start again,
one end of coil end from distributor you draw
youn think it could be the ignition switch?
yaa may be it is the ignition switch,.
×
SOURCE: 88 dodge ram charger 5.2 ltr engine....intermittant spark
pickup coil in the distributor failing get a reman distributor good luck
SOURCE: 85 dodge 360 no spark replaced, coil , ign switch,
I would suspect the ignition control if you have already replaced all that stuff. I personally would replace it with an MSD ignition for better running and fuel mileage, but the ignition module should be a whole lot cheaper.
SOURCE: 98 dode ram wont crank no spark
May have no spark due to a bad crank sensor, which is responsible for spark when it gets a pulse through the cars' computer.
SOURCE: 1992 dodge 318 engine turns over, but no start. No
if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10
1,617 views
Usually answered in minutes!
×