Went thru emissions and codes for : evap emission control sys vent control circuit came up- showes code for evap emission control sys pressure sensor low input showes code for evap emission control sys pressure sensor high input , failed in these areas- any ideas???
Your vehicle has a vent valve solenoid located on the evap canister under the back end of the vehicle. You most likely have a bad vaccuum line going to the evap caniser. Have the vehicle smoke tested to verify. If no leaks are found replace the vent valve solenoid
SOURCE: 1998 PONTIAC SUNFIRE ADVISE
Exhaust Gas Recirculation System Is the main problem here. the other code P0118 may be a bad temprature sensor or your thermostate needs to be changed. Last it could be a weak water pump.
So what is an EGR system and how does it work? EGR stands for Exhaust Gas Recirculation, and as its name implies, this system allows exhaust gasses from your car to be re-circulated into the engine, helping to reduce emissions. These systems are mostly comprised of the EGR valve, a DPFE (Delta Pressure Feedback EGR) sensor, hoses, a vacuum regulator, some vacuum lines, wiring, the computer and the exhaust tube leading to the valve itself.
The car's wiring can be tested in the normal fashion by looking for broken and lose wire, and all vacuum lines can be checked easily for cracks, leaks and correct routing.
The last thing i would then check is the the EGR valve, EGR vacuum regulator and DPFE sensor (or similar flow sensor).
I hope this helps and good luck
1,262 views
Usually answered in minutes!
×