4 wheel drive wont engage, changed the switch on the dash, still wont let me change out of 2 wheel drive
SOURCE: four wheel drive wont engage
If you have push button 4-Wheel Drive, it is recommended that you use it every once in a while, in order to keep gunk, rust, and corrosion to build up on moving parts. The mostly likeley (though not definite) reason would be that you let the 4-wheel drive unused for so long that corrosion has built up on the parts and the actuator that engages the 4-Wheel Drive doesn't have the power to engage it past the corrosion.
You'll need to take it in to be cleaned, or to have parts replaced. In the future, every month or so, engage 4-Wheel Drive and drive around in some mud, grass, sand, or any other loose ground for a bit, just to keep the parts moving and clean.
The service Four wheel drive light is to alert the operator the system is not being read properly by the ECU.
If the ECU loses contact with or position of the Transfer case actuator motor the service light will come on. Same thing goes for the front diff actuator.
So it may be a bad switch, sensor, or an actual problem in the 4WD linkage. This is not a Oil Change light that you can ignore a few extra weeks - it indicates a problem that should be taken care of ASAP to avoid costlier problems down the road.
Thanks for using FixYa - a FixYa rating is appreciated!!
SOURCE: dash light replacement
you have to take the radio apart to get to remove the face then you will need a solder gun to get the old bulbs out and put in the new ones
SOURCE: 4 Wheel Drive Problem
Put the key in the run position and turn your 4wd on and off to listen for the electronic acuator to engage and disengage. If your can hear it then it's macanical and a Quick fix. On top of the transfercase on the driver's side, your going to find three vacuume tube connected to a cauume switch that may have gone bad. There common to go bad and there not the bad of a price at the Auto Zone. Check for any cracks on the vacuume line first then get your hands dirty. Good luck and keep an extra switch in your glove box.
SOURCE: stuck in 4 wheel drive and wont come out.
hey there i cant tell you what you are missing but i can tell you how to disengage the front wheels . ok you have a vacum line that runs right under the battery and a line that comes up from the front diff. to the same place ( you may have to remove batt and batt tray to get full access to this) un bolt it and temporaly put batt and batt tray back in start it up and decompress this and see if it comes out .... you should here clunking noise if it goes back in ... if thats the case just pull that big vaccum line off .... to test get all four tires off the ground and have some one put it in drive but dont hit the gas it should turn on its own ...if that dont work check the cable that runs down to the differental
458 views
Usually answered in minutes!
×