The bad- battery light on,coolant temp reads0,up shift light doesnt work,fuel gauge always reads empty and low fuel light on the good - volt meter reads accurate,speed,tach and all other lights work.hooked laptop to obd2 and temp is accurate .what could be wrong
SOURCE: Instrument cluster on 97 Wrangler
IF YOU REMOVE INSTRUMENT CLUSTER AND UNPLUG IT,PLUG IT BACK IN AND UNPLUG IT AGAIN..DO THIS A FEW TIMES..IT SHOULD CLEAN OFF SLIGHT OXIDATION ON CONNECTOR TERMINALS..HAVE SEEN THIS BEFORE..I ALSO THINK REPAIR CONNECTORS AVAILABLE FROM DEALER
SOURCE: 2002 Chevy Suburban: Fuel gauge reads empty, tank is half full
Youre gauge is controlled by a plunger in the fuel tank which is attached to the sensor and the fuel gauge. it sounds like when the plunger goes down half way its either getting stuck down lower then it should. Needs replacing. Any mechanic can do this install for you.
SOURCE: GMC envoy after I filled gas tank the low fuel
You will need to replace the fuel level sensor which is in the fuel tank.They have a lot of problems because the metal fingers on the sensor wear off and gives you the incorrect readings.This will also cause the check engine light to come on.You will probably have a level sensor code.This will be a lot easier if the fuel level is down to about a quarter tank or less.Also you should be able to get just the level sensor and not have to get the complete fuel pump module.Good luck.
SOURCE: 99 cavalier - the fuel gauge doesnt read accurately and it jumps
Possibly a bad ground wire at the sender on the tank,
Check for that first before tearing into the dash to replace the guage.
1,156 views
Usually answered in minutes!
×