Question about 1990 Mazda Protege

1 Answer

Locate the check fill plug on the transmission for mazda b2200 truck 1992

I am trying to check and top up my transmission fluid how do i do this

Posted by itsmekr2003 on

  • itsmekr2003
    itsmekr2003 Oct 07, 2012

    where is the plug and how do i check the trany fluid level

×

Ad

1 Answer

jeff rollins

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 239 Answers
Ad

5 Related Answers

Anonymous

  • 8 Answers

SOURCE: 1992 B2200 Mazda timing instructions

this site has all the specs
http://www.mazdatruckin.com/B2200//B2200_Timing_Belt.html

Posted on May 10, 2009

Ad
Hrnsly

Romy Kettlewell

  • 154 Answers

SOURCE: What fluid Mazda B3000 automatic

we use mercon v in the trans of the b3 and b4000 trucks. Mazda recommends that the trans be serviced every 30 thousand miles this will greatly extend the life of the trans

Posted on Aug 18, 2009

Anonymous

  • 6 Answers

SOURCE: can a bad ignition switch cause the truck to die

Yes, bad ignition switch can cause that, did on my B2200.

Posted on Dec 14, 2009

Anonymous

  • 1 Answer

SOURCE: 1989 mazda b2200 can not set timing

i have a 1988 mazda b2200 and i was sittin still runnin and it was a lil low in water and i was just ab to take off when it cut off. it made steam *** out the hood. the thing is its gettin eletric to the plugs and its gettin gas and i even tried a lil eather and its turnin over it just want crank. do u have a idea wat it could b? im thinkin it jump timeing.

Posted on Feb 25, 2010

patrick lowbridge

  • 289 Answers

SOURCE: How to Fix Mazda 5 2006 Computer

if u look in the hand book it will show u how to reset the lights

Posted on Apr 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you check the transmission fluid level on a 1991 Mazda 323 with a manual transmission?


U need to check if transmission oil or gear oil is needed for ur manual trans try to locate a dipstick normally on d top part of the trans otherwise look for threaded plug again on the upper sides of d trans and ur level would be reached when oil start dripping out of the plug hole in that case no need to fill. Good Luck

Nov 16, 2016 | Mazda Cars & Trucks

1 Answer

I was wondering how do I add transmission fluid to my 1992 Mazda mx3


Automatic I pressume ! You will have a job filling transmission fluid , as oil filler is on top of transmission , and needs to be filled while on a ramp , somtime special tool need to open filley

Mar 16, 2015 | Mazda Cars & Trucks

1 Answer

Transmission hard shift


follow this troubleshooting section for oil transmission.
n automatic transmission depends on the transmission fluid for transferring engine power to the wheels, shifting gears, lubricating moving parts and cooling down the transmission. Check the transmission fluid when your car is serviced and change it as recommended. Different cars have different ways of checking the transmission fluid level; some require the engine to be shut off (e.g. Honda), some cars don't have a transmission dipstick at all and the fluid can only be checked in a repair shop. Check your owner's manual for proper procedure. This is how the transmission fluid checked on most cars: transmission-fluid1.jpg After the vehicle was driven for a while to let the transmission fluid warm up, place your vehicle on a level ground. Set the parking brake. Make sure the transmission is in "P" (Park) position. Leave the engine running. Find the automatic transmission dipstick (your owner's manual will tell you where it is located). Pull the dipstick out.
transmission-fluid2.jpg Wipe the dipstick off with a clean lint-free rag. Insert it back fully. Pull it out again and check the fluid level. A transmission fluid expands when warmed up, so if the car has been driven for a while (20-30 minutes), the transmission level should be between "HOT" marks. If the vehicle is cold, the level should be between "COOL" marks. Check the fluid condition: a very dirty fluid with strong burnt smell is a warning sign of transmission problems. Normally the automatic transmission fluid should be clean and transparent, as in these photos.
transmission-fluid3.jpg On most cars the new transmission fluid comes red (photo on the left). Over the time it becomes brownish, as in the photo below.
transmission-fluid5.jpg This is how the synthetic transmission fluid looks after two years of driving - it's still clean and transparent. If your fluid looks very dark or dirty, check your owner's manual, maybe it's time to change it. Some manufacturers require to change the transmission fluid at 30,000 or 50,000 miles others specify that you never have to change it - check what's your car owner's manual says.
transmission-fluid4.jpg If the transmission fluid level is low, you can top it up, but be careful not to overfill it. Overfilling the transmission can cause problems. It's very important to use only specified transmission fluid type - check your owners manual or simply visit your local dealer, they always have proper transmission fluid in stock. Incorrect fluid type can damage your transmission. How to top up the transmission fluid: Using a thin funnel, add a small amount of the fluid through the dipstick pipe. Wait for a few minutes - let the fluid drain down. Recheck the level again. Don't overfill

Sep 30, 2013 | 2001 Hyundai XG300

1 Answer

Transmission shifts hard


see the chart troubleshooting and proceed according. God bless you

How to check automatic transmission fluid. An automatic transmission depends on the transmission fluid for transferring engine power to the wheels, shifting gears, lubricating moving parts and cooling down the transmission. Check the transmission fluid when your car is serviced and change it as recommended. Different cars have different ways of checking the transmission fluid level; some require the engine to be shut off (e.g. Honda), some cars don't have a transmission dipstick at all and the fluid can only be checked in a repair shop. Check your owner's manual for proper procedure. This is how the transmission fluid checked on most cars:
transmission-fluid1.jpg After the vehicle was driven for a while to let the transmission fluid warm up, place your vehicle on a level ground. Set the parking brake. Make sure the transmission is in "P" (Park) position. Leave the engine running. Find the automatic transmission dipstick (your owner's manual will tell you where it is located). Pull the dipstick out.
transmission-fluid2.jpg Wipe the dipstick off with a clean lint-free rag. Insert it back fully. Pull it out again and check the fluid level. A transmission fluid expands when warmed up, so if the car has been driven for a while (20-30 minutes), the transmission level should be between "HOT" marks. If the vehicle is cold, the level should be between "COOL" marks. Check the fluid condition: a very dirty fluid with strong burnt smell is a warning sign of transmission problems. Normally the automatic transmission fluid should be clean and transparent, as in these photos.
transmission-fluid3.jpg On most cars the new transmission fluid comes red (photo on the left). Over the time it becomes brownish, as in the photo below.
transmission-fluid5.jpg This is how the synthetic transmission fluid looks after two years of driving - it's still clean and transparent. If your fluid looks very dark or dirty, check your owner's manual, maybe it's time to change it. Some manufacturers require to change the transmission fluid at 30,000 or 50,000 miles others specify that you never have to change it - check what's your car owner's manual says.
transmission-fluid4.jpg If the transmission fluid level is low, you can top it up, but be careful not to overfill it. Overfilling the transmission can cause problems. It's very important to use only specified transmission fluid type - check your owners manual or simply visit your local dealer, they always have proper transmission fluid in stock. Incorrect fluid type can damage your transmission. How to top up the transmission fluid: Using a thin funnel, add a small amount of the fluid through the dipstick pipe. Wait for a few minutes - let the fluid drain down. Recheck the level again. Don't overfill

Sep 30, 2013 | Hyundai XG300 Cars & Trucks

1 Answer

Transmission fluid pressure


The transmission is probably WAY overfilled. If you are trying to "check" or "top-off" the fluid level by removing the FILL/VENT CAP and looking in, then that is most likely the case.

The fluid is checked on that transmission by placing the vehicle on a hoist and removing the CHECK PLUG with the engine running. The fluid should just barely dribble out from the check plug when it is checked. Please note from the diagram below, that the check plug is UNDER the vehicle iand is WAY below the FILL/VENT CAP.


2_11_2012_9_04_44_pm.gif

Feb 11, 2012 | 1998 Oldsmobile Aurora

2 Answers

I have an 1998 chevy s10 automatic.this morning I noticed transmission fluid on the ground I checked and it comes out from a hose on top of the transmission but I don't see where it hook up?


From what I have read elsewhere: There is an overflow hose on top of transmission behind engine which actually is from the transfer case. Fluid will drip down onto exhaust and eventually catch on fire. Check transfer case for being overfull by taking the top fill plug out. If transmission fluid runs out, I believe the transfer case input shaft seal is shot and needs replaced. Mine caught on fire. I was lucky to get fire out before truck burnt to the ground. If you continue to drive vehicle at have something to put out a fire!!!!

Nov 13, 2011 | Cars & Trucks

1 Answer

Need to find where transmisson fluid pan is 2002 mazda 626 trying to change trans fluid & filter


  • If this is a manual then the filter on this transmission is inside the transmission and is not serviceable unless you want to pull the entire transmission and open it. You will have two plugs on the transmission. One right above the other. Pull the top plug FIRST and then the bottom plug and wait for the transmission to drain. After it drains plug the bottom hole and fill the transmission until fluid just barely seeps out the top. Then plug the top hole and this is a transmission flush on this type of transmission.

  • If this is an automatic transmission then the filter is under the transmission pan itself. Drop the pan then the filter. Clean off old gasket and install new gasket. Place new filter in and replace the pan and snug the pan bolts up. Not to tight just snug them good. Then fill the transmission with a couple quarts of fluid and turn the car on, put your foot on the brake and run the car through all gears to fill the pockets. Check fluid level and adjust accordingly.

  • If you have any questions or comments you can leave them right here.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Aug 14, 2011 | Mazda 626 Cars & Trucks

2 Answers

Trying to locate spout to add tran fluid or gear oil


  • If this is a manual transmission you will have to get underneath the car and on the transmission you will see two big plugs. This check is performed with the vehicle off.
  1. 17mm or 18mm.
  2. Top plug is the fill plug and the Bottom plug is the drain.
  3. You will need a funnel with a hose attached to it.
  4. Pull the top plug out and fill until the fluid just barely comes out and that is the proper fill.
  5. Plug the hole with the fill plug. Job complete.
  • If it's a manual it will have a dip stick or it may have a cap on top of the transmission that is commonly referred to as a "sealed transmission."
  1. Put the emergency brake on.
  2. Put the car in neutral.
  3. The check for this is a 10mm plug on the transmission. Again this has to be accessed under the car.
  4. Pull that little plug and if fluid comes out then it is full.
  5. If nothing comes out then add fluid where you removed the cap until it comes out and plug the transmission.
  6. Replace transmission refill cap.
  7. Job complete.


Regards, Tony

May 11, 2011 | 1997 Hyundai Accent

1 Answer

How do I check the transmission fluid on a manual 1995 Mazda 626 dx


On the transmission you have 2 plugs. The lower one is to drain the fluid the top one is to fill/check fluid level. Take the top one out and stick your finger in. If you get fluid its full.

Mar 26, 2011 | Mazda 626 Cars & Trucks

Not finding what you are looking for?
1990 Mazda Protege Logo

Related Topics:

534 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...