SOURCE: when I try to start
If any of the gauges are blinking and going haywire and the security light flashing then the instument cluster is faulty.But if it is just the security light flashing then its in the switch.If you only had the switch replaced then you need a new ignition lock cylinder because its worn out.
SOURCE: My van won't start... I was told that it was
Hello
What dose the van do when you turn the key dose all the light come on on the dash? Just trying to pin point your problem
Thanks
SOURCE: the car won't start; lights,
Check the starter and the starter relay or fuse. A client of mines car was doing the same thing, it ended up being two issues, the starter not working anymore, and a relay that was bad. If I am not mistaken everything should be labeled in the fuse box under the hood and will tell you where the fuse/ relay is for your vehicle
SOURCE: Nissan sentra 1993 1.6 l
Make sure you have the plug wires on the correct plug. Check the
ignition timming to make sure it is correct. After running for a few
minutes pull the pluggs to see whitch cylinders are running rich. The
fuel pressure and volume need to be tested.
1993 Nissan Sentra 1.6 liter DOHC L4 (GA16DE)
Additionally, try checking the power transistor. I will send the test. Also make sure the coil has a good ground...
Hope this helps; keep us updated.
SOURCE: security light blinks car won't start
The process for the passlock relearn is correct. If by chance the relearn does not work, you may have a fail component in the system. Go to this link for options to fix this yourself.
http://vatspasslockpasskeysecurityhelp.yolasite.com/
231 views
Usually answered in minutes!
×