PASSENGER SIDE FLOOR WATER
SOURCE: 2002 Toyota RAV4 passenger side floor Water
Hi, we also have a 2002 Toyota Rav4 and developed a leak in the front driver's side of the car. After much research, we discovered that the drain wells from our sun/moon roof were clogged. If you have one of these, I suggest that you open the sun roof and look carefully. You will notice some tiny little holes in front and in the rear of the sun/moon roof tracks. Over time, these become clogged with dust and debris. You need to find a long, sturdy piece of thin wire and run it down the holes. To test if you have properly unclogged these, take a small amount of water and pour it down the holes. You should see water coming out of the drain wells under the car around the rear of the front tires. Hope this helps.
SOURCE: wet floor
If this has happened since you started using the A/C it is probably the drain tube for the A/C. They get plugged and usually someone has to go under the car with a coathanger and open the tube up.
SOURCE: 2002 Camry water on drivers side floor whenever it
There are three possibilities, the winshield seal is leaking, the door seal is defective or the door window seal is leaking, sometimes you can find out by having an assistant inside the car observe the areas mentioned while you spray the car with the pressure washer at the car wash.
SOURCE: Where is the A/C drain tube on 2007 Camry?
in engine bay there are to bent pipes with caps on the them. on says H the other L. take the caps off and get a screw driver and a rag. place flat blade in the valve once you have taken the cap off the low side. and push the valve in causing the A/c gas out, the a/c gas can frezz in seconds so place rag over and dont let gas touch skin. one youv done low side do the same to the high side.
SOURCE: I have a 1999 Camry LE driver and passenger side floor is wet
if it has sunroof the drains are bad for getting clogged (pinestraw dirt and grime) open sunroof half way pour small amount of water in front corners make sure it drains from under car at pinch weld if not you will need to have them cleaned with compressed air
1,058 views
Usually answered in minutes!
Try wiping sealant with your little fingertip round under the lip of the gulley outflow from the engine compartment, where it sits on the wheelarch (passenger side). You'll need to clean as best possible first, with rag and white spirit, along that roughly 50mm seam where the pinhole manufacturing defect is. This all has to be done from above as the channel is inaccessible even when wheelarch liner is removed. Regards Andy
×