Question about Cars & Trucks

1 Answer

\]]]diagram for installment of vaccum hoses,the wiring on a1984 dodge ram van. also for the throttle I,m almost on begging terms..Ha ha , totally Serious! the dodge van has a 318 motor b250

Posted by kelli on

Ad

1 Answer

Colin Stickland

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 22,485 Answers

Sorry cannot help here as never seen one here in spain,try a direct to one of the american mechanics on here is best answer i can give

Posted on Sep 22, 2012

Ad

5 Related Answers

michigan man

edgar walker

  • 3533 Answers

SOURCE: i dont have the diagram

normally the diagram for the fuse box is just inside the lid and my suggestion to you is to stop by a dodge dealer and the parts department would print you off a diagram

Posted on Jan 08, 2009

Ad

scott

  • 532 Answers

SOURCE: vaccum hose diagram for 88 chevy truck

it may not be a vacumn leak from a line,check the throttle shaft for movement,for example,i had a 89 1 ton 350 and my throttle shaft was moving around a lot and in order to keep it from idling high,i had to kick the throttle pedal.But also check the idle air control valve,which is the round sensor on the side of the throttle body.

Posted on Sep 11, 2009

emissionwiz

Marvin

  • 85239 Answers

SOURCE: distributor firinng order wiring diagram 1998 ram 1500 318 4x4

GO TO THE LINK BELOW FOR INFO U NEED.

http://autorepair.about.com/library/firing_orders/bl-fo-4555.htm

Posted on Nov 06, 2009

morse008

Duane Morse

  • 1111 Answers

SOURCE: Dodge ram van stalls when RPM are low

could be fuel filter clogged //fuel pump is going bad which you will need to have a pressure test done ...also is there a gas odor ? could be rusted lines could be air filter ....messing with the timing you should not move to much ...if you have brake /carb choke cleaner try spraying around the intake manifold to see if any change in performance such as lowering the rpm's which would mean a gasket leak are all the Vacuum lines good and not dry-rotted try bending them ans well as spraying with a squirt bottle of water on the plug wires to see if an Arc is present a bad plug wire ..these are a few areas in which i would consider 1st ..hope this helps you

Posted on Dec 03, 2009

Anonymous

  • 1 Answer

SOURCE: 1989 Dodge Truck B250 Van V8-318 ignition control

its built into the ecm located right in the middle of he firewall from under the hood, big black box with two plugs.

Posted on Apr 19, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 dodge ram stalls while driving


Make sure you don't have any vacuum hoses of on the intake. If that doesn't work check mass airflow sensor. Unplug sensor if it run better with out the sensor being plugged in the replace. You can blow the sensor out with mass air flow sensor but I have not ha the best luck with this product.

Mar 07, 2015 | Dodge Ram Cars & Trucks

1 Answer

Shaking while driving


The shaking can be the brakes, rotors, tires, poss alignment or wheel balance. It may also be connected to that CV boot that is torn and leaking which affected the axle. It has to be lifted & checked out. Good luck

Mar 08, 2017 | 2005 Dodge Ram 1500

1 Answer

I have a 2001 dodge ram van 3500 wuth a 5.2 and i am trying locat the cank position sensor where can it be


it goes between the trans and engine on the passenger side take off the inside cover to see it

Jul 17, 2012 | 2001 Dodge Ram 3500 Truck

2 Answers

2002 honda civic wiring diagram


Hi,
http://www.installdr.com/Harnesses/HA-Wiring.pdf
pls rate my suggestion,,,,,

Jun 24, 2009 | 2002 Honda Civic

1 Answer

Where is the location of the egr valve on the 4.7 liter engine


ha ha thats a fun one.. look on the drivers side of engine next to the firewall, behind the throttle body.

Dec 18, 2008 | 2005 Dodge Ram

1 Answer

Engine lite came on and i got a 110C code


Sounds like maybe an intake air temperature sensor acting up. No need to panic, but if it continues have it scanned & replaced if needed. Sometimes they will correct themselves, if it was a sudden temerature change outside. Sorry with late reply, weekends almost over. ha-ha

Nov 22, 2008 | 2005 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6523 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...