P1457 check engine light

https://www.obd-codes.com/p0128

https://www.obd-codes.com/p0141

https://www.engine-codes.com/p1457.html

P1457 EVAP control system leak (EVAP canister system)

Read this post to understand how EVAP systems work. Then you'll have to find out where it's leaking
http://ricksfreeautorepairadvice.com/evaporative-emissions-system-primer/

Check out this link. Also remember to unhook battery to reset the "check engine" light (unless you have the tool for it).
https://www.youtube.com/watch?v=Jl14guRsJrw

Having changed the canister vac valve you may have a connecting hose leaking.

this code is sometimes set because of a loose gas cap or a leaking gas cap. the code is set when the fuel vapor management system detects a leak.

the light is on because you have a problem with your engine, get it scanned by a sparky to find out what is wrong

SYMPTOM
The MIL is on, and DTC P1457 [leak detected in EVAP
control system (EVAP control canister system)] is set.
PROBABLE CAUSE
The EVAP bypass solenoid valve can fail due to
corrosion. Replace the bypass solenoid valve first. Clear DTC's and test drive.

p1457-try by putting fuel fill cap on only about 3 turns and see if this helps. if it does not help. check all vacuum lines to and from charcoal canister. good luck, it very hard to tell. but there is a vacuum leak somewhere in system.

Interior lights do not turn on when door is opened. I checked the fuses and they appear good

A very common late 90's code, P1457 is a failure in one of the evap system solenoid valves. There are 2 culprits, the Vent Control Valve & the 2 Way Bypass Valve. So, start working with those and see if you can get the 1457 code off of it.

I also looked around about the 1739 code as well which a transaxle error. However, I've found that there has been more than enough reported cases of problems of the such. Take a look at this link, and do a little reading.

http://www.hondacarforum.com/honda-2/13499-trouble-code-p1739.html

I hope this helps you out.