Question about 2002 Isuzu Rodeo
Posted by Anonymous on
pull the starter away from the bellhousing and turn the drive end upwards then it will come out from the engine compartment tight i know but i have just done mine so i know it will come
Posted on Mar 30, 2009
SOURCE: 2000 isuzu Rodeo wont start
Could be your neutral safety switch, or it's not all the way in park. Broken or loose wires in the starting circuit. Inspect all wires and connectors at the battery, starter solenoid, and ignition switch. Or your starter pinion is jammed in the ring gear. Remove starter and inspect. Last but not least, your engine is seized. You don't want that one. Good luck.
Posted on May 22, 2009
disconnect the battery first. remove the 3 bolts connecting the starter the the bellhouseing, the remove the wires. install in reverse order
Posted on Jun 04, 2009
SOURCE: 2002 isuzu rodeo won't start
the clutch switch is located on the clutch pedal support, if you put your hand on the clutch pedal run your hand up and the switch will be at the top. now if you are going to replace this switch I would try to adjust the switch first the amount of time it takes and this would confirm that it's the switch. ensure clutch pedal is fully returned, disconnect the electrical connector from the switch. loosen lock nut and tighten clutch switch by hand until switch is firmly against clutch lever. back the switch out 1/2 turn, the switch plunger should extend .02-.06" (.5-1.5 mm).
hope this helps
Posted on Jul 13, 2009
Tips for a great answer:
Oct 30, 2015 | Isuzu Rodeo Cars & Trucks
Oct 30, 2015 | 2002 Isuzu Rodeo
Aug 21, 2014 | 2000 Isuzu Rodeo
Sep 10, 2012 | 2002 Isuzu Rodeo
Jul 09, 2011 | 2002 Isuzu Rodeo
Dec 28, 2010 | 2002 Isuzu Rodeo
Jul 13, 2009 | 2002 Isuzu Rodeo
73 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: