SOURCE: how to remove and replace Tata Indica gearbox
not a bad little car i think,done one last year for a new clutch and i it was that easy that i honestly do not remember having any problems with it ,only one tip i will offer though and i do this on all motors and thats to drill a hole in the bellhousing with a hole cutter big enough to get a 10mm socket 1/4 drive through the hole to tighten the clutch bolts ,getting to old to struggle now so i make a hle that aligns up with the clutch bolts then fit bolts holding the clutch finger tight then once the box goes in nice and easy as the clutch plate can move a bit then two big bell housing bolts in and then rotate the flywheel twic tightening the bolts one by one .easy better than hurting ones back with a struggle
SOURCE: how do i check timing marks on tata indica lsi
The timing marks are notches on the engine block and all the pulleys that the belt goes around! Before removing the belt make sure all pulleys are in line with there mark! If not sure contact your local mechanic!
1,918 views
Usually answered in minutes!
×