Question about 1995 Chevrolet K2500
Brand new ip, fuel filter runs good for a while than starts bogging out than runs fine than bogs out i stop shut off the truck starts running fine for a while than all of the above starts all over
SOURCE: 1995 Chevy silverado with a
I have experienced this problem on similar vehicles. You should try and replace the coolant temp sensor. If it is not reading the correct temp to the ecm, it will not get the right fuel map. Also, the cts will not always throw a code.
Posted on Aug 04, 2008
The cylinder 7 misfire is likely a symptom of the problem, not the problem itself.
Typically, the catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate. The downstream 02 sensor reading should be fairly steady. Typically the P0420 code triggers the check engine light if the readings of the two sensors are similar. This is indicative of (among other things - such as faulty sensors in the "emissions loop") a converter that is not working as efficiently as it should be.
I do not believe that it is a problem with a valve/head gasket or cam.
Posted on Jan 13, 2009
SOURCE: 1997 chevy silverado 3500 with
We found the problem by taking the truck to the dealership, after spending $550.00 on parts and having everything we could remove tested or we purchased them new and replaced them. We spent two weeks on it and took it to Chevrolet but it took them three days after all we had done, the problem turned out to be the gear on the distributor, sure we replaced every part in it but because we could not get the distributor out with the intake on it we had not even considered the gear, thanks for your assistance and maybe we'll try you again next time....Thanks again.
Posted on Jan 17, 2009
Chevy Trucks, Blazers, S10 pickup and the like will vapor lock ecspecially the 2000 models. Do not tighten the gas cap past 1 click. There is a tube that runs from the top of the tank down and this gets hot and collapses or burns in half. We just bought a reinforced rubber tube cut it to lengh and use it instead of part and it's worked grat for 2 years so far.
Posted on Feb 01, 2009
If you have fuel on the vacuum side of the reg, that means the reg is leaking,causing a variaty of drivabiliy problems. Replacing this reg is very straight forward. Just add a little lube to the O-ring on the reg before installation. Good luck.
Posted on Apr 23, 2009
Tips for a great answer:
Oct 14, 2013 | 1989 Chevrolet S-10 Blazer
Nov 06, 2012 | 1986 Nissan Maxima
Sep 05, 2012 | 2005 Dodge Stratus
Dec 19, 2010 | 1987 Toyota Pickup
Jun 08, 2010 | 2000 Chevrolet Express Cargo
Jan 28, 2010 | 2001 Chevrolet Monte Carlo
Mar 05, 2009 | 1998 GMC Sierra
May 09, 2017 | 1995 Chevrolet K2500
152 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: