Question about 2005 Nissan Almera 1.5
This solution will be of great help to you,even in the case of future or other dashboard problems;
Instrument cluster consists of electronic analog gauges, various warning lights, and optional tachometer. Vehicles equipped with tachometer have an electronic vacuum fluorescent transmission range indicator (PRND3L),odometer and trip odometer display. Vehicles without tachometer are equipped with a cable-operated transmission range indicator.
Instrument cluster is equipped with the following warning lights:
Cruise (speed control).
Fasten seat belt.
Lift gate ajar.
Low fuel level.
Low windshield and washer level.
The Body Control Module (BCM), which receives input from various sensors, sends display information to instrument cluster and operates gauges. Instrument cluster incorporates a self-test diagnostic feature to identify electronic problems. BCM, Powertrain Control Module (PCM), and Transmission Control Module (TCM) are continuously monitored by the diagnostic system.
With ignition off, press and hold TRIP and RESET buttons while turning ignition switch to ON position. Continue to hold TRIP and RESET buttons until odometer window displays CODE (approximately 5 seconds). If problem exists, system will display diagnostic trouble codes. See DIAGNOSTIC CODE CHART table. If no problem exists, Code 999 (end test) will be displayed.
DIAGNOSTIC CODE CHART
110.......Cluster Memory Fault
111.......Cluster Calibration Fault
905.......No CCD Bus Message From TCM
921.......Odometer Fault From BCM
940.......No CCD Bus Message From PCM
After diagnostic code display ends, instrument cluster will go into each of the following tests in order:
Odometer segment test.
Electronic Transmission Range indicator segment test.
CHEC-0 will be displayed in odometer window. Instrument cluster will dim Vacuum Florescent (VF) display. If VF displays do not dim, a problem in instrument cluster exists. See BODY CONTROL COMPUTER TESTS in BODY CONTROL COMPUTER article.
CHEC-1 will be displayed in odometer window. Each of instrument cluster gauges will move sequentially through each calibration point. See GAUGE CALIBRATIONS table. If gauge needle is not calibrated properly, a problem in instrument cluster exists.
Odometer Segment Test
CHEC-2 will be displayed in odometer window. Each segment of odometer will light sequentially. If any segment does not light, replace instrument cluster.
Electronic Transmission Range Indicator Segment Test
CHEC-3 will be displayed in odometer window. Each segment of electronic transmission range indicator will light sequentially. If any segment does not light, replace instrument cluster.
Posted on Sep 10, 2012
Have some one scan your car for diagnostic trouble codes. There is an emmision control fault that should be taken care of or it could lead to further problems. The fluid coming out of the tailpipe is normal. Gasoline has a certain percentage of water in it and what doesn't get evaporated comes out the taipipe.
Posted on Jan 31, 2010
Tips for a great answer:
Jan 08, 2016 | Nissan Cars & Trucks
Jul 08, 2015 | 2005 Nissan Almera 1.6
May 03, 2015 | Nissan Cars & Trucks
Apr 12, 2015 | Nissan Almera Cars & Trucks
Aug 16, 2012 | 2005 Nissan Almera 1.6
Dec 31, 2010 | Nissan Se R Cars & Trucks
Aug 15, 2009 | 2003 Nissan Altima
1,528 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: