Question about 1996 Chrysler Town & Country

2 Answers

I have a code 123155 what is it i own a 1996 Chrysler Town & Country

Posted by hobbymiser25 on

Ad

2 Answers

ZJ Limited

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 17,970 Answers

Mayvbbe is...12 - Battery was disconnected recently
31 - Purge canister/EGR solenoid circuit is open or shorted
The possible causes here could be:

- Bad connection or wiring... check the wiring and connections between the logic module and the solenoid. Clean and regrease any corroded connectors with dielectric grease and repair any shorts.
- Bad solenoid... the solenoid is located in the right, front fender next to one to three other solenoids. 55 - End test.
Really you have a 31 fault code there, 12 and 55 is a informative code.
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Posted on Sep 05, 2012

Ad

Stephen

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 21,873 Answers

Well engine trouble codes are only 4 digits long. So is that more than one code ?

Posted on Sep 05, 2012

Ad

5 Related Answers

dj_relly999

dj_relly999

  • 4070 Answers

SOURCE: Describe your 2004 Chrysler Town &

u may try checking the wirings of the front blower, it may be corroded thats why its losing contact, hope this helps

Posted on Jul 03, 2009

Robert Debison

  • 412 Answers

SOURCE: 2002 Chrysler Town & Country Evaporator leak

THERE ARE SEVERAL EVAP HOSE LEAK SPOTS ON THESE VEHICLES..UNDER VEHICLE BY EVAP CANISTER,UNDER AIR CLEANER..ALSO LDP VENT VALVE NOT HOLDING VACUUM WILL SET A LEAK CODE..SMALL BLACK VALVE WITH A HOSE ON EACH END WITH A SMALL VACUUM HOSE ON TOP..IT SHOULD HOLD VACUUM WITH HAND HELD VACUUM PUMP..HAVE ALSO SEEN SPLIT HOSES NEAR EVAP SERVICE PORT LOCATED NEXT TO AIR CLEANER HOUSING

Posted on Jul 05, 2009

ROB

  • 858 Answers

SOURCE: i have a 1997 chrysler town & country,my

Hi the codes refer to a transmission
shift solenoid fault! ok
Cheers Rob.

Posted on Jul 20, 2009

Robert Debison

  • 412 Answers

SOURCE: Describe your 2006 Chrysler Town

P0404 IS EGR POSITION SENSOR PERFORMANCE..YOU NEED A NEW EGR VALVE..RECOMMEND DISCONNECTING BATTERY WHILE REPLACING EGR VALVE..SOMETIMES CODE WILL NOT GO AWAY EVEN AFTER REPLACING VALVE AND CLEARING CODE WITH SCANNER..VALVE IS LOCATED ABOVE ALTERNATOR ON END OF CYLINDER HEAD..THE BOTTOM BOLT CAN BE TRICKY TO REMOVE AND HAVE HAD TO REMOVE ALTERNATOR TO GET BOLT OUT..YOU WILL NEED A NEW GASKET FOR TUBE AS WELL..ABOUT 120 BUCKS FROM DEALER(CAN)

Posted on Jul 27, 2009

Jason Johnson

  • 1619 Answers

SOURCE: Chrysler Town & Country Minivan Rear Drum Brakes

remove tire remove center pin and nut if needed and any othe bolts then pull straight off. Make sure parking brake is released or drum will not come off.

Posted on Apr 16, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Chrysler Town and Country won't start. Lights, radio and horn works just fine. Even put in a new starter and still get nothing. Ran a wire from battery to the starter and got a little kick.


Chrysler Town & Country Questions - My van won't start ...

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusSep 29, 2008 - ckf2004 answered 4 years ago. I have a 96 chrysler town and countrylx and the engine died, turned over but wouldn't start, I researched and replace the flywheel .... My van sometimes won't start because it kills the battery.

My town & country 2004 wont start sometimes - CarGurus

www.cargurus.com > Questions > Chrysler > Town & Country

CarGurusMy town & country 2004 wont start sometimes - My van start doing something really weird. it will ... Asked by TownCountryguy May 03, 2013 at 03:31 PM about the 2004 Chrysler Town & Country Base .... Sometimes you tap it & it won't work.

Van won't start - Chrysler town and country - YouTube

? 1:01
https://www.youtube.com/watch?v=mkEL2vlLZr0
Jun 26, 2014 - Uploaded by Philip Walker
We have the same issue currently...very randomly...with our 2008 Caravan at the moment. Wife just got ...

2011 Chrysler Town & Country Engine Won't Turn Over, Will ...

www.carcomplaints.com/Chrysler/Town_Country/.../engine_wont_turn_...
The 2011 Chrysler Town & Country has 34 complaints for engine won't turn over, will not start. Average repair cost is $902.00 at 58178 miles.

Jan 14, 2016 | Chrysler Cars & Trucks

1 Answer

Why my 2001 town & country 3.8 will not shift gears?


p1784 shift up /down wire open,,,P0700 Transmission Control System Malfunction

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com

P0732 Gear 2 Incorrect ratio

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com

Apr 23, 2015 | 2001 Chrysler Town & Country

1 Answer

Can I put a 2003 town & country transmission into a 2002 town & country


most likely it will fit unless the manufacturer changed the application that year but its not likely suoldnt be a problem

Mar 03, 2013 | 2002 Chrysler Town & Country

1 Answer

My 2005 Chrysler Town & Country 3.8L V6 . just started misfiring


possible bad injector - recomend have injector checked and or do compression test on cylinder # 2

Jul 07, 2012 | 2005 Chrysler Town & Country

2 Answers

Check engine light comes on. odb2 code P2096 What does it mean


WHAT EXACTLY MEANS THE CODE P2096 AND HOW I SHOULD FIX IT CRYSLER 300 2010

Apr 24, 2010 | 2005 Chrysler Town & Country

1 Answer

1997 chrysler town & country was cutting out,died,now wont start


you need to put a scanner on it and see what code comes up.
my guess would be the crank sensor which is very common .

Feb 12, 2010 | 1997 Chrysler Town & Country

1 Answer

Chrysler trouble code U110C on 2005 chrysler town


encrypted software ,dealer only----yes i know you are showing a reading but it doesnt mean anything or if it does it shows a different code .so your snap on or mac tools scanner is a waste of time and money.Nearly all new motors from 2005 are using encrypted software to stop general mechanics like me from working

Sep 12, 2009 | 2009 Chrysler Town and Country

1 Answer

Describe your 1996 Chrysler Town &


HAVE SOMEONE EXTRACT THE CODE FROM THE CAR'S COMPUTER. IF THERE IS A CHECK ENGINE LIGHT ON THEN THE PCM HAS A CODE STORED ON IT. IT SOUNDS TO ME LIKE A THROTTLE POSITION SENSOR, BUT JUST CHECK THE CODE TO BE SURE. SOME OF THESE CAN ALSO HAVE A BAD IDLE AIR CONTROL VALVE. I HOPE THIS HELPS YOU TO FIND THE PROBLEM. PLEASE KEEP ME POSTED, THANKS FOR USING FIX-YA. GOOD LUCK

Aug 28, 2009 | 1996 Chrysler Town & Country

1 Answer

Trouble codes on a 2000 Chrysler town and country


0775 is Presure Control Solenoid "B", 0784 is 4-5 Shift these are trans codes from the transmission Solenoid. This is a changable part for any mech. Part is around $200 & includes the gasket.

Jun 26, 2009 | 2000 Chrysler Town & Country

Not finding what you are looking for?
1996 Chrysler Town & Country Logo

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...