thanks! I'll have that checked. it runs fine, it just that when I stop for a light, when I step back on the gas it bogs down & tries to stall.unless I hold 1 foot on the gas.thanks! I'll have that checked. it runs fine, it just that when I stop for a light, when I step back on the gas it bogs down & tries to stall.unless I hold 1 foot on the gas.
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check temp sensor and TPS, throttle positioning sensor.The power control module,"pcm.is a possible thought.Just check all connections. It is always a good idea to spray WD 40 or equivalent in the connections.
Make sure it's getting fuel. Try using some ether or starting fluid. If it rumbles to life but doesn't stay running then there's a problem with the fuel delivery system. i.e.... Fuel pump, clogged filter, pressure regulator.... If the ether doesn't change the results you are getting now then it's a fire or sensor problem. Ignition coil, relays, sensors not signaling, PCM... I wish you luck. Let us know how it turns out
all code readers will retrieve information stored while in the on position --doesnt need to be running ---when you rehook up scanner either resubmit or edit request with codes
A few different things could be going on here. Some things to check: possible vacuum leak, TPS (throttle position sensor), IAC (idle air control valve). I would check these first. Is the ck engine light on? If it is, take it to your local O'Rielly's or Auto Zone, they will scan it for free. Hope this helps, TJ
when you hold the accelerator does the vehicle stay running? if so the problem is in ithe IAC idle air control motor, take a small screw driver and using the handle tap the iac motor and usualy the motor will kick in and the vehicle will run fine then if the problem is rectified replace the IAC
×