Can't get wash fluid to mix/spray out of Honda

Check for the whirring sound of the water pump when you pull the wash switch. It is located at the bottom of the fluid container. If no sound, the pump maybe dead. Check voltage supply at the connector to the motor too.

The washer fluid is frozen and the pump is stuck in ice.

Defective steering gear is most likely cause of this

1. the washer fluid jets are plugged possibly and will not allow fluid to discharge. Take a small wire or needle and stick into the jet end where the fluid comes out and it should spray after that if that is the issue.
2. the lines coming from the washer pump could be broken or cut open. Remove the line at the back of the spray jet either at the hood or at the wiper arm, then attempt to spray the wiper fluid. If it does not spray then there is an open/broken line coming from the washer pump or the pump may have a problem. If fluid is coming out of the line, the jet again is plugged up. Also check to see that fluid is going into the washer pump (locating the pump and getting to it is sometimes not so easy depending on where the mfg put the pump).

If you can hear the washer bottle motor then you know its not an electrical problem, if you can see the fluid in the lines then the best thing to do would at each connection in the hose disconnect the line and operate the washes and see if the fluid comes out (also pay attention to pressure) do this until you reach the washer nozzles. The nozzles could be blocked. now you might say that you put new lines on so the nozzles shouldn't be blocked well if you think of it the previous hose could have been partly bocked thereby stopping any **** that is at the filter on the washer motor going anywhere(most modern cars have filters on the washer motors) So by putting new lines on you have allowed the **** at the motor travel all the way to the nozzles letting them get blocked.
Hope this helps.

Speak english! Don't panic say it slowly!

do you hear the mini washing water pump noise (working)? if no: check fuse panel where labled washer... if yes: there could be a blockage in the very fine sprays ontop of hood, due to prevoius not clean water used before or any pricipitant..... you need to use a very thin wire or tool to clean it

replace pump

WHEN YOU TURN ON WASHERS CAN U HEAR THE PUMP WORKING IF YOU CAN IT WILL BE
BLOCKED WASHER JETS OR LINE OR WASHER PUMP IS FAULTY.

pull hose off sprayer and check for water pressure if pump is pumping water then jet is blocked use a small sowing needle in the jet to unblock jet dirty water blockes them get someone to hold the swich down while u do this wear saftey glasses when u do this u dont want dirt in your eyes

PLEASE RATE THIS HELP