Abs light comes on and is most apparent when first moving car while the wheel is turned and the accelerator is pressed. Computer is showing a B1226 code.
Loose axle, bad wheel bearing, or bad speed sensor
SOURCE: 2003 silverado 39,ooo miles. due
make sure all tires are same size and inflated to correct pressure
SOURCE: ABS BRakes
Check the brake light switch at the pedal. However an overheated/melted
bulb base means arcing to me. So, BOTH sockets are probably slightly
corroded & rusted. You fix that by scraping the terminals inside
the socket with a pocket knife or screwdriver. Clean with alcohol or
contact cleaner. If the new bulb isn't tight, and can be moved back and
forth by hand, bend the contacts inward slightly, but don't snap them,
they are spring steel. I was wondering when somebody would ask this
question. I fix them at least to once a month - not the same car, but
all GM's, and when fixed, they're good. Use logic if centre
safety/brake light works.
The remote start sounds normal. There are many different types and they are quirky.
You should scan for codes with an OBD II scanner. If the problem was in
the brake light connections or is fixed at the pedal, erase codes. It
could be, by coincidence, and in no relation whatsoever to this
problem, that a front wheel bearing sensor has gone - they do that, and
require a new hub assembly.
SOURCE: abs wheel sensors on 2004 chevy tahoe
yes they are four wheel abs that means there are four sensors one for each wheel
SOURCE: 2003 chev. silverado2500hd, abs goes off, pulsates when stopping
Gm has tech service bulitens on this issue.First the abs sensors can and should be removed,inspect the sensor mounting surface for rust (clean w/ sandpaper) insp the sensor (note the sensor may break w/ trying to remove so be gentlel) if all looks ok reassemble and test drive. if unwanted abs still persists both hub bearings should be replaced (call your dealer and ask if a special policy exsits for this condition) usually no abs code w/ be present Good luck Ray..
SOURCE: abs and t/c lights are
When there is such a feeling, it is the brakes that needs total replacement.
Also you might have to check the master brakes for any leaks. And you need to check the bushing rubbers on the steering rack too.
Be careful and fix this on time.
Rate this solution.
1,123 views
Usually answered in minutes!
×