Quest code p1136 - 2005 Nissan Quest

"Long term fuel trim"; it's running a little too lean. Check your fuel pump pressure & flow.

Here try this solution...You posted P1479. ...When this fault is stored in conjunction with misfire and system lean fault codes check the PCV system and any other possible sources of engine mechanical vacuum leaks. Although PCV failure is most common on the 1.8T engines equipped with the auxiliary vacuum pump, any engine with low vacuum can cause that electric pump to run excessively - resulting in this fault code. Good luck.

P1136 NISSAN - Intake Valve Timing Control Solenoid Valve Circuit Bank 2

Possible causes- Intake valve timing control solenoid valve bank 2 circuit is open or shorted.
- Intake valve timing control solenoid valve bank 2 circuit connectors
- Intake valve timing control solenoid valve bank 2
P1124 NISSAN - Throttle Control Motor Relay Circuit Short

Possible causes- Throttle Control Motor relay harness is open or shorted
- Throttle Control Motor relay circuit poor electrical connection
- Fualty Throttle Control Motor relay

DTC P1136
Long term fuel trim, idling, bank 1 - system too lean.

You're getting too much air (port restriction, vacuum leak) or not enough fuel (clogged injectors, fuel pump or filter issues).

it is under the lower intake manifold.

go here for help

http://autos.groups.yahoo.com/group/villagerquest/

need to know what level of radio you have. There are 3.

go here for quest help

http://autos.groups.yahoo.com/group/villagerquest/

The service engine light on is not a big deal. you just aren't meeting emissions right now.

Go to Autozone and have them run a free scan to get fault codes.

Just remember this - do not ever change the knock sensor even if it gives a fault code. It is in the middle of the engine and a waste of $600 for no improvement. It will never affect your engine performance, good or bad.

report back with code here or on Villager- Quest website I gave you.

http://www.radio-code.com/

I have a used Nissan Quest 1999 that Remote Control does not work . How can I program it?