Question about 1988 Honda Prelude

Open Question

Replace fog light bulb on 1988 honda prelude - 1988 Honda Prelude

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 2 Answers

SOURCE: 89 honda prelude power steering belt

there is an adjustment bolt on the back side of the idler pulley . you just loosen up the nut on the front of the pulley , then turn the 12 mm bolt under the pump on the back side of the pulley.

Posted on Jul 29, 2008

Ad
shop242

Tommy Moore

  • 214 Answers

SOURCE: oil light reset procedure for 92 honda prelude

theres a lil slot on the lower left face plate of the dash.. Insert Ignition key or suitable tool (very small screwdriver) and hold for a few seconds.. this will reset the mileage counter and turn off the oil lamp.. Thankx

Posted on Mar 12, 2009

Ad

Anonymous

  • 116 Answers

SOURCE: Honda Prelude Sunroof

go to a Honda Dealership and ask them to order a new sunroof gasket replacement kit. they have em and they may even have instructions on how to remove the old and install the new. I've had awesome experiences with the Honda parts division. Hope this was the answer you wanted. (don't even look for an after market one..unless you want a nightmare)

Posted on Mar 15, 2009

c17hydro

Greg Bernett

  • 2989 Answers

SOURCE: how to change fog lights bulbs on my 2005 honda

548ae69.gif

  1. Remove the fog light mounting screw.
  2. Disconnect the connector from the fog light.
  3. Turn the socket about 45° counterclockwise and remove it from the housing.
  4. Remove the bulb from the socket.
To Install:
  1. Install the bulb in the socket without touching the glass with bare hands.
  2. Turn the socket about 45° clockwise to install it.
  3. Connect the connector to the fog light.
  4. Install the fog light mounting screw.

Posted on Jul 15, 2009

Anonymous

  • 32 Answers

SOURCE: fuel pump location

there are two locations one is inside the fuel tank and the other is beside the fuel tank before the fuel filter

Posted on Oct 03, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing the heater core


Hey Eric,here's a guide on how to replace.

Jan 17, 2013 | 1988 Honda Prelude

1 Answer

Blinkers not working fuses ok


mcdevito75 here, If the fuses are ok, Check the bulbs themselves, also the Flasher unit sometimes located in the fuse box is faulty, also chek the wireing to the back lights for a good ground.

Jun 18, 2010 | 1988 Honda Prelude

1 Answer

Replace fog light bulb for 2006 Honda Odyssey


Touring Model
Use a wrench to remove the mounting bolt from the underbody through the hole in the splash shield.
Remove the fog light assembly from the bumper by pulling its inner edge first, then the whole assembly out of the bumper.
Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.
Remove the bulb from the fog light assembly by turning it one quarter turn counterclockwise.
Push the electrical connector onto the new bulb.
Turn on the fog lights to test the new bulb.
Reinstall the fog light assembly into the bumper. Tighten the mounting bolt.
Insert the new bulb into the assembly and turn it one-quarter turn clockwise to lock it in place.
Hope this helps you.

Nov 22, 2009 | 2006 Honda Odyssey

1 Answer

My 1988 honda prelude 2.0 si left headlight broken cant figure out how to take it off and replace it, the motor still works I hear it try to lift the headlight up but isn't it connected the arm is snapped...


its easy i did mine you have to buy the whole light not just the bulb. All you gotta do it unscrew the black plastic around it and then pop the light out. make sure to check it works before srewing it back in

Oct 06, 2009 | 1988 Honda Prelude

1 Answer

How to change fog lights bulbs on my 2005 honda


548ae69.gif
  1. Remove the fog light mounting screw.
  2. Disconnect the connector from the fog light.
  3. Turn the socket about 45° counterclockwise and remove it from the housing.
  4. Remove the bulb from the socket.
To Install:
  1. Install the bulb in the socket without touching the glass with bare hands.
  2. Turn the socket about 45° clockwise to install it.
  3. Connect the connector to the fog light.
  4. Install the fog light mounting screw.

Jul 14, 2009 | 2005 Honda Odyssey

1 Answer

1988 honda prelude windows and sunroof won't work


There is a relay, and it should be in the fuse box. If it's not there, you may have a Constant Control Relay Module (CCRM). It's a big black and silver box around the radiator. The relay could be housed here. If so, you'll have to replace the entire box as these relays are not serviceable.

Jul 01, 2009 | 1988 Honda Prelude

1 Answer

Cambelt


You can download the entire manual from www.pdftown.com
Here is the link to the shop manual for the 88 prelude that I used to do my Cam Belt.
http://pdftown.com/Honda-Prelude-1988-Service-Manual.html
Hope this helps...

Apr 13, 2009 | 1988 Honda Prelude

2 Answers

Clutch goes to floor without engaging


how do you bleed a hydrolic clutch on a 1988 Honda Prelude

Aug 10, 2008 | 1988 Honda Prelude

Not finding what you are looking for?
1988 Honda Prelude Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...