They have snap clips. use a small screw driver and push it in and pull the blads out.look at new ones for clarification.
SOURCE: The passenger windshield wiper does not work
if you have only one wiper arm moving then your wiper linkage is broken i get used wiper linkages from the auto recyclers to remove the old one you have to remove the 2 wiper arms raise them up and slide the little clip out to hold it upright either pry or wiggle the arm off then undo the screws for the grill under the wiper arms while the hood is raised undo the bolt on the wiper motor etc. replace the part and put everything back together you may have to try putting the wiper arms on a few times until it doesn't hit the edge of the windshield and retracts down properly $40 (Canadian) for used parts if you do it yourself $90 - $130 in new parts maybe $140 - $200 in parts and labor to have someone else do it
SOURCE: 2004 grand prix driver side wind shield wiper
The arm is stripped onto the stud its pressed into which is call a wiper transmission. That part mounts to eack ww blade then to the wiper motor. You need a new transmission and maybe a new wiper are as well
SOURCE: help stuck n storm..where is fusebox 2004 murano windshieldwipers
There's no need to remove the fuse to change wiper blades.
If there are electrical problems the fuse locations are driver's bottom left near steering wheel, and under the hood. Under the hood is the ipdm located on the passenger side near the alternator. More fuses can be found beside the battery.
If your wiper motor runs but wipers don't move, the linkage is disconnected.
SOURCE: 2004 GMC Envoy rear hatch complete door wont
door lock actuator solenoid ( inside of door) needs to be replaced
80 views
Usually answered in minutes!
×