I worked on the car replacing top gasket and cylinderhead, previous one was worn out
You can obtain the images here, we do not have the,.
SOURCE: bmw 316i
hi markjones, the ignition switch can usually be removed without too much disassembly. First you will need to remove a plastic screw in the upper and lower trim covers. Seperate the covers. You should see a black plastic ring around the mechanical switch. gentley remove the ring. Next remove the rubber o-ring/band. With the key in the iginition and turned to almost to position 1, insert a heavy duty paper clip, or bmw special tool (about $30 from the dealer) into the small hole in the switch. There is a cam in the hole that needs to be twisted clockwise so the cylinder can be removed. When installing a new switch make sure to remove the little tab pice of metal that usually breaks off in the housing. Also be sure to make sure and reinstall the rubber ring/band because they are part of the ews system. If you key turns continuously, or is not able to be removed, the ignition housing and cylinder both will need replaced. Replacing the lock housing is about a 2 hour sequence and can be challenging. I would recommend a shop for that kind of repair.
SOURCE: Radiator removal BMW 316i
hi, the two clamps that secure the radiator have a small slot on the top, if you insert a small screwdriver into the slot and use it as a pry bar you should be able to unclip the holding clamp and it then releases like a hinge.
SOURCE: Car radio security code
i had the same problem with 323i..
take stereo to your to bmw
and with the serial number they
should be able to tell you your code
SOURCE: bmw 316i E36
To set the timing you should turn the No.1 piston to TDC, then turn the cam to where both valves on No.1 are close. The timing mark on the sproket should now be in line with the mark on the cilinder head. With No. 1 still on TDC fit the chain.
After fitting turn the engin a few times by hand to make sure there's not a valve pushing against a piston.
SOURCE: bmw 316i overheating
check if the water is circulating as you might have a blockage in the header tank. this can be checked by opening the radiator cap and check if the water is circulating on top.
321 views
Usually answered in minutes!
I cannot found marks on the cylinderhead and on the crank shaft of car
You can obtain the images here, we do not have the,.
×