Where is the camshaft sensor located on a 2000 honda passport

A camshaft position (CMP) sensor is typically only used as a reference for sequential fuel injection into the cylinders by the powertrain control module (PCM). Technically speaking, the 2000 Honda Accord doesn't have a CMP sensor, rather a cylinder position sensor (CYP). This should not be confused with the crankshaft position sensor (CKP) which is primarily used for ignition timing. There are also two different engine options for the vehicle being the 2.3L 4-cylinder engine and the 3.0 V6 engine. Sensor locations will be different for each option so it's important to first identify which engine is in the vehicle. The CYP sensor for the 2.3L 4-cylinder engine is located inside the distributor and is not serviceable; the whole distributor would need to be replaced. The CYP sensor for the 3.0L V6 on the other hand is located behind the left camshaft pulley on the timing belt back cover and is a serviceable part. You can read more here: https://www.yourmechanic.com/article/how-to-replace-a-camshaft-position-sensor-by-mia-bevacqua

https://www.google.com/?gws_rd=ssl#q=Camshaft+sensor+location+1999+honda+passport+V6

Hope this helps

see the diagram and videos I found for you. The fir5st one gives a brief overview and removal instructions




2007 Honda Civic Camshaft Crankshaft Position Sensors Location 2010 honda accord camshaft position sensor Google Search Repair Guides Electronic Engine Controls Camshaft Position Sensor AutoZone...

On the WEB
images for 2000 honda passport thermostat location

There are 2 camshaft sensors A and B, on the back of the cylinder head.behind the intake cam and the exhaust cam. They are directly THe crankshaft sensor is on the timing chain cover, low down near the crankshaft. Can you give some more details?

Honda calls them Top Dead Center sensors and there are 2 of them. The connector is shown in the picture. Follow the wires to the sensor.

one for each tire.
it senses tire to road RPM (speed) and if a tire slips braking
it modulates that tire/wheel brake line to prevent a skid.
so 1 per tile wheel.
the FSM covers all this, read it
or login to alldata.com and read the theory. its all there.
or wiki ABS. its there too.

Check the IAC (Idle Air Control) valve, it is located by the Throttle Body.

Its in the egine. its under your spare tyre storage.

Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.