Question about Chevrolet Cars & Trucks

1 Answer

Where is front brake line located on k2500 chev 1990 pick up

Where is front brake line located on chevy k2500 1990 pick up?

Posted by Biz Help on

Ad

1 Answer

Mobile mechanic

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 295 Answers

Well it depends do you need to get to the one behind tire or under hood there should be several break lines comming off brake resevoir

Posted on Aug 24, 2012

Ad

5 Related Answers

Richie_asg1

Richard Perkins

  • 1036 Answers

SOURCE: replace brake pads on chev. colorado pick-up

90% of the time the sequence is identical.

Slacken wheelnuts.
Jack up and support on axle stand.
Remove roadwheel.

There should be two bolts holding the brake caliper on - usually on the inside.
Slacken both, but only remove the lower one.
The caliper should then be able to swing up pivoting on the top bolt.
You can remove this top bolt, but support the weight of the assembly with wire to the suspension spring - so as not to stress the brake hose.
Remove the brake pads, and clean the areas the pads seat on.

Push back the pistons. Some require a special tool, most make do with a wooden packer and suitable large lever - or G clamp.

Fit new pads. Pay particular attention to any fitting clips, springs, rods or pins that are needed.

With new pads in, swing down caliper into position. Fit new attatchment bolts or use a threadlock on fixings. & tighten.

Still with wheel off, depress brake pedal to activate brakes - & check for leaks and working.
With foot off brake, check hub turns with no problems.
Refit wheel and repeat for other side.

ALWAYS replace brakes in axle pairs.

Hope this helps.

Posted on Jun 14, 2008

Ad
keemo68

Ronald Mueller

  • 1263 Answers

SOURCE: where is the dimmer switch

the dimmer switch is located in the steering column and is a part of the turn signal module. you must remove the steering wheel,column cover to remove the turn signal/dimmer switch module.

Posted on Apr 17, 2009

keemo68

Ronald Mueller

  • 1263 Answers

SOURCE: does my 1990 chevy k2500 have a t350 transmission or 700r4?

more than likely it has a 700r4. full size trucks came from the factory with that transmission. most t350's came in mid size cars

Posted on May 10, 2009

Anonymous

  • 232 Answers

SOURCE: need Rear Brake Diagram for 1994 Chevy K2500 4x4

Here is the diagram,It is always a good idea to only disaasemble one side so you can use the other side as a reference,I also reccomend using a set od brake pliers,they will the disassembly and reassembly much easier.
0900c1528008f6a2.gif

Posted on May 30, 2009

dennymulford

Dennis Mulford

  • 1055 Answers

SOURCE: rear brakes locked up. 1990 chevy c1500 2wd pickup

did you see if they need replaced?
and also the emergancy cable may be froze

Posted on Aug 12, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Location of horn relay for 1990 Chevy k-2500 5.7l


Can't say for sure don't have that manaul but look inside the glove box for a plastic cover it will say relays .The 1st is the fuel pump 2nd I belive would be the horn 3rd would be the fog lights .They are all the same and can be swooped out for each other to test them .

Apr 21, 2015 | 1990 Chevrolet K2500

1 Answer

Broken brake line on 1990 chevy 4x4 pickup (K1500) broke and drained master cylinder. Front disc brakes/rear drum brakes. ABS system. Once brake line fixed what is the bleeding procedure that must be...


1990 Chevy 4.3 l engine runs rough at idle half the time-- sometimes it's OK, other days it's rough and can smell raw gas, as tho it's running rich... any ideas?

Nov 27, 2010 | 1990 Chevrolet K1500

1 Answer

1990 chevy k2500 5.7 tbi.. truck just died, engine turns over but no spark. replaced coil and still no spark.


Is there power to the coil?? is there spark coming out of the coil? Is coming out of dist cap? could be a distrubutor, pick up, module, rotor? we could guess all day , but it really needs to be checked out.

Nov 12, 2010 | 1990 Chevrolet K2500

1 Answer

4 wheel dr doesnt seem to engage on 1990 chevy


there is a vacuum diaphram that pulls the cable check to see if it is holding vacuum

Nov 30, 2009 | 1990 Chevrolet K2500

1 Answer

1990 CHEVY PICK UP 4 WHEEL DR DOESN'T SEEM TO BE ENGAGING REAR WHEELS SPIN


just make sure it dose not have manual front locking hubs where you have to turn the dial on each of the center hubs on the ft wheels to the lock position before shifting into 4wd

Nov 30, 2009 | 1990 Chevrolet K2500

1 Answer

Jingling noise? 1990 chevy k2500


If you had front disc brakes changed recently, then more than liklely someone forgot to put your anti rattle clip in with the installation. if you can stand the rattle it's not life threatning. if no brake job recently, then open the hood and look for something loose that would be rattling.

Jun 23, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

Need Rear Brake Diagram for 1994 Chevy K2500 4x4


Here is the diagram,It is always a good idea to only disaasemble one side so you can use the other side as a reference,I also reccomend using a set od brake pliers,they will the disassembly and reassembly much easier.
0900c1528008f6a2.gif

May 30, 2009 | 1994 Chevrolet K2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...