Question about 1986 Volvo 760

1 Answer

Wont fire I CANT GET MY CAR TO RUN NO SPARK AT PLUGS

Posted by edward_stanc on

Ad

1 Answer

ivan whisker

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Volvo Master
  • 1,164 Answers

Get coil packs checked thats about all it cold be

Posted on Aug 17, 2012

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont start no spark at plugs: what provides spar or fire to plugs. (94 tercel)


run fault codes
could be a broken timing belt
problem crank/ cam position sensor
immobilizer not working

Sep 01, 2018 | Cars & Trucks

1 Answer

My car wont run - changed the spark plugs and crankshaft sensor


Cars require three things to run.Spark, air and fuel.Take out a spark plug ,ground it to the engine,isolate yourself from the plug,and have someone crank the car over.Since the plugs are new they should work if not you have an ignition problem.If you have spark pop out the plugs and squirt some gas into the combustion chamber,replace the plugs,and crank the car .If it fires for a couple of seconds and then dies you have a fuel delivery problem,such as a bad fuel pump. I empathize with you ,a no start can be very frustrating but the above gives you a place to start Let me know how you make out,good luck.

May 05, 2014 | Mazda Protege Cars & Trucks

1 Answer

My 1999 expedition wont start. your guy said it may be the pump, the the fuel shut off switch then the relay. not any of the above. whats the problem?


ok first check for fire at spark plugs if there is no fire then your problem could a sensor could be a crank or cam sensor or disconnected wire, check all your fuses, inside engine compart. and (inside the car) you need 3 elements for the engine to run, fuel,air and fire, if one of those is not present then your car wont start, it will turn over but wont run.

Apr 07, 2011 | Ford Expedition Cars & Trucks

1 Answer

Engine missing wont fire properly, i think its the spark plugs how do i change them ?


CHANGE SPARK PLUGS.YOU NEED SPARK PLUG 3/8 SOCKET.YOU NEED SHORT AND LONG 3/8 EXTENSIONS.YOU NEED SPARK PLUG BOOT PULLER AND A SPARK PLUG GAUGE SET THE SPARK PLUG GAP.NOW CHANGE 1 SPARK PLUG AT A TIME SO YOU MIX THEM UP GET FIRING ORDER MIX UP CAR BACK FIRE WONT CRANK.ALSO CHANGE PLUG WIRES ALSO.

Nov 10, 2010 | 1994 Honda Civic

2 Answers

My car wont start after i changed spark plugs and wires.


did u mix the plug leads up when u replaced them wrong firing order 1342

Apr 02, 2010 | 1994 Honda Civic

1 Answer

Change spark plugs and now car wont start.....1994 ford tarus


Do you have the "firing order" correct? In other words, is each spark plug wire going to the same cylinder it was on before you changed the plugs? If you have done nothing else but changed the plugs then this is the most likely problem.
If when you try to start the car it backfires through the exhaust or backfires through the intake. Then this " IS" the problem. Good luck.

May 23, 2009 | 1994 Ford Taurus

1 Answer

Need firing order diagram.. wont start


remove the dizzy cap, crank motor over to find out the rotation of the rotor. Remove the no.1 spark plug and bring no.1 piston up to top dead centre on compression stroke, mark side of dizzy body where the end of the rotor points to, replace dizzy cap and see which lead it lines up with.
that will be your no.1 lead, find the firing order and put the leads back on the dizzy cap in the direction of the rotors rotation, run those leads to the corresponding plugs and it should start.

May 19, 2009 | 1979 Lincoln Mark V

2 Answers

98 dode ram wont crank no spark


May have no spark due to a bad crank sensor, which is responsible for spark when it gets a pulse through the cars' computer.

Apr 24, 2009 | Dodge Ram 1500 Cars & Trucks

1 Answer

Car runs bad after replacing spark plugs and wires


Make sure the part store gave you the correct plugs and wires. Consult a third source for a firing order.

Jan 06, 2009 | 1992 Mazda Protege

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Vincent G
Vincent G

Level 3 Expert

2363 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...