How to remove ford taurus window switch - 1998 Ford Taurus

Remove screw on panal around handle that opens car. remove 2 screws underneath handle that pulls door closed. check around door panal edge for screws and if so remove them. Now remove panal by prying slightly around edges or panal as to pull the clips loose. Dont bother if some break,they can be easly replaced and dont cost much at all. I always use a still putty knife to help pry panal off. This insures you dont crack panal while pulling on it. Once thjis is dont you will have access to the switch...Simply replace it and place panal back on and HEY !! you did it..... hope this helps and if so Please leave rating on this post and good luck..

Door Panels

• REMOVAL & INSTALLATION

Print

REMOVAL & INSTALLATION

See Figures 1 through 8
This procedure applies to both the front and rear door panels.

Fig. Fig. 1: Remove the cover from behind the inside door handle by gehow to remove ford taurus window switch - 0900c152802604e5.jpgto release the retaining tabs

Fig. Fig. 2: Remove the pull cup retaining screw cover and...

Fig. Fig. 3: ... remove the retaining screw from the cup and lift the cup straight up out of the door panel


how to remove ford taurus window switch - enlarge_icon.gifig. 4: Remove the two sail panel/how to remove ford taurus window switch - enlarge_tooltip.gifining screws and...

Fig. Fig. 5: ... remove the panel/grille from the door


how to remove ford taurus window switch - 0900c152802604e9.jpg/images/0900c152802604e8.jpg" alt="0900c152802604e8.jpg" class="h_mi" />

Fig. Fig. 6: The door panel is retained to the door by 11 retaining clips

Fig. Fig. 7: Carefully lift the door panel off of the door and...

Fig. Fig. 8: ... detach the electrical connectors from the switches and remove the panel from the vehicle

1. Remove the cover behind the inside door handle.
2. Remove the screw from the bottom of the pull cup retaining the front door trim panel to the front door.
3. Remove the two screws retaining the sail panel/speaker grille assembly and remove the panel/grille from the door.
4. Remove the three screws retaining the front door trim panel to the front door.

1. Use a suitable tool to remove the pushpins from the door.
2. Carefully lift the door panel away from the door.
3. Detach the electrical connectors as necessary and remove the panel from the door.

1. Installation is the reverse of removal.