Well i tried to open the back hatch and the handle would just keep spinning so i got inside and i finally got it open but i already know if i close it back it will not open again. Is there something in the handle that i am missing or am i just gonna have to buy another something if i have to buy....what do i get?.............
My friend, recheck the handle hook up, something might not be working or connected properly. Is it electrical or mechanical issue? Please be more specific.
Difficult to guess without seeing it.
Once the interior panel is removed it should be possible to figure out how it should work and from there figure out why it doesn't work and then verify your conclusion by dismantling and examining the components.
SOURCE: Passenger door lock on explorer not opening
you are going to have to replace the lock buttom actuator motor.
SOURCE: 1998 toyota 4 runner back hatch handle broken
get inside the back take door panel off mipulate door latch to open
SOURCE: Broken rear hatch door handle on Toyota Sequioa
It sounds like the handle has become disconnected from the mechanism. You will have to remove the inner door panel and reattch. It is not a complicated or difficult job but if you get a professional it could cost upwards of $100.
SOURCE: trunk/hatch will not open. handle seems loose.
2000 ford explorer back hatch handle loose door locked The linkage on the back hatch came unfastened and the handle was loose. Ford uses plastic fastener clips over perfectly good threads to hold this together. The outdoor plastic handle is only conected to the car with two aluminum ribets. One was already missing on mine. But if you just want to open the door, you can rip the handle off and pull it out. hopefully you won't crack the plastic. You can see the linkage screw hanging as you look up through the left hole. Grab it with a plyers and apply a steady force down. This will open the hatch. I just rigged up a different handle and put a nut on the treads to hold it together. This can all be done without tearing appart the interier and may only take 20 minutes. I used a rope and handle from the garage opener, a medium size washer and a nut. First make a small loop, with a small hole to slide over the linkage screw, then the washer, then the nut. Slide the other end of rope through the handle, move the handle very close to the vehicle and tie the not close. Trim the rope and wala ... the hatch works. Or you can pay $300.00+ to have it fixed with the clip.
SOURCE: Ford Expedition rear hatch won't open
where is the rear door fuse located on a 2000 ford expedition?
91 views
Usually answered in minutes!
×