Mazda familia 1.3 1992 engine revs but will not pull when driving untill it warms up

Replace the coil pickup located in the distributor under the rotor-they are common problems, lots of people who off-road with jeeps carry an extra because they do this.

Apr 01, 2011 • 1998 Jeep Wrangler

3helpful

1answer

My 2004 RX8 won't start when the engine is warm, when its cold it starts no problem. If I drive the car till it at operating temp and shut it down I have to wait an hour until start it again

if this car is on the cold start injector when it is defective. Injects additional fuel to the engine is still warm. Is it to feel warm by running more than normal gasoline smell?

Mar 15, 2011 • 2004 Mazda RX-8

0helpful

2answers

1997 Mazda 323 Familia a/t wont run immediately

sounds like torque converter but also check shifter alignment.

Aug 18, 2009 • Mazda 323 Cars & Trucks

2helpful

1answer

Engine warms up then engine revs up high.....

replace idle control sensor.

Aug 07, 2009 • 1991 Mazda MX-6

0helpful

1answer

Mazda Sentia 929 auto failure

Rebuilt gearbox probably... unfortunately!
If the HOLD light in the in strument cluster is flashing at you, it is giving you a transmission diagnostic code (like a kind of Morse Code). A transmission specialist or a Mazda Dealer will be able to read this code and plug their computer into the cars computer, and tell you what is wrong.

Feb 28, 2009 • 1993 Mazda 929

0helpful

1answer

Check Light on and switch off in the morning mazda tribute 2002

need to scan possible computer problem

Feb 09, 2009 • 2002 Mazda Tribute

Question 2

Anonymous

Expert 32 Answers
Posted on Aug 11, 2012

Anonymous

Expert

Joined: Aug 11, 2012

Answers

32

Questions

0

Helped

14933

Points

101

Fuel filter

Answer 2 · 5/19/2008 12:00:00 AM

Anonymous

2 Answers
Posted on May 19, 2008

SOURCE: 1992 mazda mx6 idle issue

check all the small rubber vacuum pipes for any splits, cracks or deterioration etc, also check that their connections are clean & tight.

Anonymous

3 Answers
Posted on Feb 21, 2009

SOURCE: Check Light on and switch off in the morning mazda tribute 2002

need to scan possible computer problem

Anonymous

1 Answer
Posted on May 09, 2009

SOURCE: Mazda Familia '98 engine tune up

maybe u have sliding clutch... i have my mazda familia gen2 1600cc ...i can even bit the other 1600cc.. mazda is fast..

Anonymous

2 Answers
Posted on May 11, 2009

SOURCE: Mazda Sentia 929 auto failure

Rebuilt gearbox probably... unfortunately!
If the HOLD light in the in strument cluster is flashing at you, it is giving you a transmission diagnostic code (like a kind of Morse Code). A transmission specialist or a Mazda Dealer will be able to read this code and plug their computer into the cars computer, and tell you what is wrong.

Dar

2007 Answers
Posted on Aug 07, 2009

SOURCE: engine warms up then engine revs up high.....

replace idle control sensor.

Answer 3 · 5/19/2008 12:00:00 AM

Anonymous

2 Answers
Posted on May 19, 2008

SOURCE: 1992 mazda mx6 idle issue

check all the small rubber vacuum pipes for any splits, cracks or deterioration etc, also check that their connections are clean & tight.

Answer 4 · 2/21/2009 12:00:00 AM

Anonymous

3 Answers
Posted on Feb 21, 2009

SOURCE: Check Light on and switch off in the morning mazda tribute 2002

need to scan possible computer problem

Answer 5 · 5/9/2009 12:00:00 AM

Anonymous

1 Answer
Posted on May 09, 2009

SOURCE: Mazda Familia '98 engine tune up

maybe u have sliding clutch... i have my mazda familia gen2 1600cc ...i can even bit the other 1600cc.. mazda is fast..

Answer 6 · 5/11/2009 12:00:00 AM

Anonymous

2 Answers
Posted on May 11, 2009

SOURCE: Mazda Sentia 929 auto failure

Rebuilt gearbox probably... unfortunately!
If the HOLD light in the in strument cluster is flashing at you, it is giving you a transmission diagnostic code (like a kind of Morse Code). A transmission specialist or a Mazda Dealer will be able to read this code and plug their computer into the cars computer, and tell you what is wrong.

Answer 7 · 8/7/2009 12:00:00 AM

Dar

2007 Answers
Posted on Aug 07, 2009

SOURCE: engine warms up then engine revs up high.....

replace idle control sensor.

Related Topics:

Mazda familia 1.3 1992 engine revs but will not pull when driving untill it warms up

1 Answer

Anonymous

5 Related Answers

Anonymous

Anonymous

Anonymous

Anonymous

Dar

Add Your Answer

Attachments: Added items

Related Questions:

My 2000 Mazda etude 160i starts jerking when the engine starts to warm up. Please help

Runs good from cold, but once warmed up it has a flat spot just above idle when I give it some throttle. When pulling up hill at low revs {1500-2200} it jerks and won't pull cleanly till revs get up.

My mazda premacy 2003 lights flashing on and off on the dashboard when driving. The revs are up to 3000 at a speed of 50km/hr. Fuel consumption is very high.

When I start my 1997 miata it revs almost up to 3000 rpm where it stays for at least 15 minutes before warming up.

My 91 wrangler will idle just fine and drive fine for the most part but it seems to be after about 15 min. of driving it will cut out on me and then it will pick back up sometimes...sometimes i have to...

My 2004 RX8 won't start when the engine is warm, when its cold it starts no problem. If I drive the car till it at operating temp and shut it down I have to wait an hour until start it again

1997 Mazda 323 Familia a/t wont run immediately

Engine warms up then engine revs up high.....

Mazda Sentia 929 auto failure

Check Light on and switch off in the morning mazda tribute 2002

Not finding what you are looking for?

1996 Familia

My 2000 Mazda etude 160i starts jerking when the engine starts to warm up. Please help

Ask a Question

Check Out the Latest Top Trucks Report!

Top Mazda Experts

ZJ Limited

Ronny Bennett Sr.

Thomas Perkins

Are you a Mazda Expert? Answer questions, earn points and help others

Manuals & User Guides

Related Topics:

Mazda familia 1.3 1992 engine revs but will not pull when driving untill it warms up

1 Answer

Anonymous

5 Related Answers

Anonymous

Anonymous

Anonymous

Anonymous

Dar

Add Your Answer

Attachments: Added items

Related Questions:

My 2000 Mazda etude 160i starts jerking when the engine starts to warm up. Please help

Runs good from cold, but once warmed up it has a flat spot just above idle when I give it some throttle. When pulling up hill at low revs {1500-2200} it jerks and won't pull cleanly till revs get up.

My mazda premacy 2003 lights flashing on and off on the dashboard when driving. The revs are up to 3000 at a speed of 50km/hr. Fuel consumption is very high.

When I start my 1997 miata it revs almost up to 3000 rpm where it stays for at least 15 minutes before warming up.

My 91 wrangler will idle just fine and drive fine for the most part but it seems to be after about 15 min. of driving it will cut out on me and then it will pick back up sometimes...sometimes i have to...

My 2004 RX8 won't start when the engine is warm, when its cold it starts no problem. If I drive the car till it at operating temp and shut it down I have to wait an hour until start it again

1997 Mazda 323 Familia a/t wont run immediately

Engine warms up then engine revs up high.....

Mazda Sentia 929 auto failure

Check Light on and switch off in the morning mazda tribute 2002

Not finding what you are looking for?

1996 Familia

My 2000 Mazda etude 160i starts jerking when the engine starts to warm up. Please help

Related Topics

Ask a Question

Popular Questions

1995 mazda familia fuse box diagram?

Removing stereo in a mazda

Cigarette lighter fuse location for a Mazda Famillia, it's not there in front under the hood and also under the steering wheel. Can't find it please help.

My car battery keeps going flat ive brought a new battery and had the alternator replaced and yet my car keeps going flat

Backfire problem and bad smell smoke

Check Out the Latest Top Trucks Report!

Top Mazda Experts

ZJ Limited

Ronny Bennett Sr.

Thomas Perkins

Are you a Mazda Expert? Answer questions, earn points and help others

Manuals & User Guides