I folded down the rear seat in my 2005 a6 and now the seat belt is stuck and the seat will not fold back up
SOURCE: audi timing belt
It's a complicated job, and usually takes about 8 hours to do the full service if you're familiar with the car's mechanicals, you have a good array of tools (air tools help a lot), you're familiar with what you're doing, and with how to disassemble everything (including removing the front of the car - I'm not joking). There's more to the job than just the belt too - you need to replace the timing belt, timing tensioner, water pump, thermostat, serpentine belt, and serpentine tensioner. If your cam seals are leaking (which is also known to happen), you'd need those and plan for a couple more hours as well, due to the care that must be taken not to scratch or score the cam end caps.
SOURCE: Audi A6 How do I replace Serptine Belt?
In response to BiTurboA6 comment, there is a full write-up at http://www.scribd.com/doc/12127197/2001-Audi-A6-Alternator-Replacement-Instructions
SOURCE: how do i change time on clock on 2005 audi a6 quattro s line
I think I can help you. I just did this on mine yesterday because my clock runs a few minutes fast each month. It was somewhere bizarre - sorry I'm not near the car to be more clear. I think I picked Sound, Settings and for some odd reason, it was there, rather than in Car, Settings. NOOO - it was in Tuning - click the AM/FM button, then Settings. I've only had it for a few months, but you'd think I'd have that one figured out due to re-setting it.
-maria
SOURCE: HOW TO REMOVE FRONT SEATS AUDI A6 YEAR 2000
You need to access bolts that are bolted to the floor, disconnect wiring, move the seat forward and look from the rear seat down under, you will see bolts..
SOURCE: How To Change Rear Brake Pads on Audi A6 2006
Remove the tires, Remove the calaper bolts, (small heads on them 12mm or so) Remove calaper, Pads are setting in a holder. Lube new pads with litheum grease and place in holder. (look at old pads, one or both may have small metel tab on one end) If the new pads have the tab, put that pad where the old pad with the tab was. (ie. tab to the inside) Press pistion in with a 'C' clamp. If it won't go in easly, it may screw in. If the parking brake cable is hooked to the calaper, it probly screws in. Use large pliers to screw in calaper piston. Place calaper over pads and install bolts (lube bolts) Rember to pump brakes befor driving . to get a solid peddle.
174 views
Usually answered in minutes!
The seats dont fold down on the 2005 A6. Maybe on the wagon they do but not on the sedan
×