TOO MUCH FLUID IN RESERVOIR

From the 2013 operators manual;

Push the windshield wiper lever forward to spray washer fluid on the rear window. The lever returns to its starting position when released.

The windshield washer reservoir is used for the windshield and the rear window. Check the fluid level in the reservoir if either washer is not working.

Check fuses or washer pump. .replace.

Does the pump motor run when turn windshield spray?
Might be home in line.
Might be wrong fluid(too thick)
Might be wiper fluid motor broken.

the low washer fluid sensor might be shot. try replacing it. hope this helps.

The motor is most likely in the wiper fluid reservoir. Remove reservoir and disconnect motor, supply 12 volts to the motor if it's ok it should spin, spraying fluid every where. DC motors immersed in fluid don't alway last. Replace motor if it does nothing.

Check the rubber hoses to the sprayers. If they are on the hood they can come unplugged when you open it. Have a friend work the sprayers as you watch for leaks. An old toothbrush can be used to clean spray nozzles by scrubbing over the hole.

CHECK WIPER FLUID LEVEL FIRST ALL IS GOOD CHECK FOR POWER AT WIPER WASHER PUMP MOTOR.IF NO POWER AT WIPER WASHER MOTOR.CHECK 15 AMP FUSE IN THE ENGINE COMPARTMENT FUSE RELAY BOX.IF YES YOU ARE GETTING POWER AT WIPER WASHER MOTOR.WIPER WASHER MOTOR FAULTY.

Try standing outside of the vehicle and having someone press the "juice" button and listen to see if the motor is trying to spray. If it is....check to to see if you have contaminents in the windshield wiper fluid reservoir.

It does not take very much dirt in the washer fluid reservoir to plug the nozzles for the windshield washers. check for dirt in the reservoir and clean out if need be. If you are in below freezing temperatures make sure your washer fluid is good for below freezing. mike

WHEN YOU TURN ON WASHERS CAN U HEAR THE PUMP WORKING IF YOU CAN IT WILL BE
BLOCKED WASHER JETS OR LINE OR WASHER PUMP IS FAULTY.