Question about 2004 Mazda RX-8

1 Answer

The mazda rx8 is hard starting and not idling properly. How do u set the timing for the rotas. Do u have a diagram

I need a diagram showing how to set the timing for mazda rx8, 2005 model

Posted by Michael wason on

Ad

1 Answer

John Bond

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 101 Answers

There are no timing on the rotors for a wankel engine. The timing is controlled by a computer for the RX-8. The sensors & distributors can be adjusted on the RX7's & other Mazdas but I know that there were major engine changes to the RX-8 so I can't tell you for sure. I use to have an RX-7 and worked on it all the time.

Posted on Aug 03, 2012

Ad

5 Related Answers

Bob B

  • 272 Answers

SOURCE: mazda rx8 fault code p0410

The P0410 code refers to the (secondary air system) emissions system. The AIR pump puts air to the exhaust to lower emissions. It takes in outside air and pumps it through two one-way check valves into each bank of the exhaust.
.
About 90% of the time that this code is set, the one-way check valves have worn out or failed and allow water (which occurs naturally in the exhaust) back into the pump. In any cold climate, especially in climates with higher humidity, this water may be more excessive. The water partially fills the AIR pump, it can then freeze. When the PCM commands the pump on, if the pump is frozen it cannot turn, thus overloading the circuit and "popping" the fuse.

A code P0410 may mean that one or more of the following has happened:

  • Water may have collected in the AIR pump or the vent solenoid and frozen or corroded the pump
  • Blown AIR pump fuse due to freezing up
Possible solution:
This may be covered under the emissions warranty on the vehicle. If your vehicle is out of bumper-to-bumper warranty, check if the emissions warranty is still valid!
  • Replace the AIR pump AND one-way check valve
  • Test and clean the AIR pump AND test and replace the one-way air check valve
  • Replace the AIR pump inlet hose
  • Replace the AIR pump fuse (found under the hood)
It is really only an emissions issue and won't harm your car's engine ot drivetrain. It will however mean you won't pass emission testing if you live somewhere that tests for that like I do!

Posted on Jun 03, 2009

Ad

gav

  • 91 Answers

SOURCE: program keyless entry for mazda rx8

its a dealership and computer job by them, you cant do it yourself

Posted on Jul 25, 2009

gav

  • 91 Answers

SOURCE: Mazda rx8 2005 owners manual

does not exist for free you have to buy one

Posted on Jul 25, 2009

ourhowse

Dar

  • 2007 Answers

SOURCE: mazda rx8 rough idle and stalls when at operating

If there are no vacuum leaks, change idle control sensor.

Posted on Jul 28, 2009

bschilz

Bill Schilz

  • 2049 Answers

SOURCE: serpentine belt diagram mazda 6 2005

Here are links to the diagram...

If your engine is the 2.3L 4 cyl... http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7042

If your engine is the 3.0L V6... http://www.gates.com/common/part_locator/view_diagram.cfm?id=S6036

Posted on Sep 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need timing belt marks diagram for mazda 323 160i , 2001 model, zm engine


11_30_2012_7_10_14_am.jpg
I would have liked to add as an attachment but could not.

Nov 30, 2012 | Cars & Trucks

1 Answer

My mazda 323f 1.6 twincam 2002 model has an oil leak from crankshaft pulley area,to solve the fault will probably involve removal of timing belt/belts,is there any advice/diagrams for strip-down procedure...


1997 Rover; Saloon car; cc rating 1580.
Need a diagram and markings to set the crankshaft & twin overhead camshaft timing; What is the firing order before TDC

Dec 09, 2010 | Mazda 323 Cars & Trucks

1 Answer

What do timing marks on a mazda 626 yr 2000 4cyl cam gears look like


Click on the following free, direct Link. It has all the Timing Belt Diagrams you will need, complete with Instructional and Directional Diagrams to set your Timing.

Let me know if this helped or if you have additional information or questions. Feel Free to contact me at FixYa.com!


http://www.2carpros.com/car_repair_information/year/2000/make/mazda/model/626/2000_mazda_626_timing_belt_diagram_marks.htm

Mar 29, 2010 | 2000 Mazda 626

2 Answers

Need timing marks on dual cams for 2001 mazda protege dx 1.6L


Click on the following direct Link. It has the Tining Belt Diagrams that will match your specific engine. Included are instructions and directions.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!


http://www.2carpros.com/car_repair_information/year/2001/make/mazda/model/protege/2001_mazda_protege_timing_belt_diagram_marks.htm

Mar 18, 2010 | 2001 Mazda Protege

1 Answer

Changed timing belt car takes a little time to start.


My apologies for the delay...
Click on the below Link. It has all the Diagrams of the Timing Belt and Pulley you will need.
Before Clicking, let me know if this helped you.
Again my apologies...

http://www.2carpros.com/car_repair_information/year/2000/make/mazda/model/626/2000_mazda_626_timing_belt_diagram_marks.htm

Jan 24, 2010 | 2000 Mazda 626

1 Answer

Mazda b 2500 how to set timing when the timing belt has broken in


My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following LINK. It has the Timing Belt and Mark(s) Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/1998/make/mazda/model/b2500/1998_mazda_b2500_timing_belt_diagram_marks.htm

Apr 19, 2009 | 1998 Mazda B-Series

1 Answer

How do you time a 4 cyl, and a diagram for those timing marks locations


if u go on yahoo.com type 1995 mazda 626 timing and click on search images you will see a picture of how to set it.

Sep 20, 2008 | 1995 Mazda 626

10 Answers

Need to know how to time my car


how do i get the timing back where it belongs on my 2006 chrysler 300 i messed with it before i realized it had marks

Jul 23, 2008 | 1995 Mazda 626

2 Answers

1996 Mazda Etude 160 Timing Belt


The timing belt has 123 teeth, and ussualy the marks are little paints. align them together and then you will have ur problem solved.

Jun 21, 2008 | 2004 Mazda 3

Not finding what you are looking for?
2004 Mazda RX-8 Logo

1,126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...