My 2 motor mounts are bad on my 1993 jeep grand cherokee, i need to know how to get the old ones off and 2 new ones on. please help.
SOURCE: 1993 Jeep Grand Cherokee, V6. Oil Pressure Gauge Read High.
it could be the sensor you should look at the oil pressure relief valve
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: window motor replace 2001 jeep grand cherokee
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
SOURCE: blower motor jeep cherokee 1993
Review the Jeep XJ Service Repair Manual (page 24 for Blower Motor Fan replacement).
I hope help you with this. Good luck (remember rated this help).
SOURCE: oil pump replacement
all you really have to do is drop the exhaust headers in order to get the oil pan out, are you sure it is the pump though, experience sayd the pressure switch is far more likely to cause a lack of oil pressure that the actual pump.
396 views
Usually answered in minutes!
×