2002 maxima- some times the car won't start using the original keys. after trying for a while one of the keys will work. another problem, this just happened, while driving the car shut off break peddle did not work, power steering did not work, all the lights on the dash board turned on and car shut down. what causes this??
SOURCE: 96 NISSAN MAXIMA SHUTS OFF UPON DECELLERATION OR WHEN STOPPED
Check to see if the floor on the passanger side is wet. If so, than your A/C drain clogged up and your ECM/computer got flodded by water causing all sorts of funky stuff happening. Right next to the gas pedal is a small cover attached to the computer. It has a clip in it. Remove the clip and tug on the cover. Look at the top of the computer to see if its rusted up. Remove the other side cover also, which is on passanger side floor next to your left foot(if you sitting in passenger seat). and check other side of ECM/computer. Check the ECM for rust on top.
If ALL of that looks OK, than I would replace the switch,(since you are telling me that the key got VERY hot) that is mounted on the back of the ignition cylinder. Its a white round switch that failes after a while especially car beeing 1996, just think about how many times that ignition has been turned ON/OFF since 1996. The mechanism in the switch failes, causing starting issues and funky electrical issues.
Does the car have a remote starter installed?? Or didi it have one in the past?? I have seen companies that install them cause some damage to the harnesses on the switch that is mounted to the back of the igniton cylinder. They use "scotch locks" to connect the remote starter and after a while the connection corrode and cause problems too.
Anyways, check the computer for rust first. Than I would install that switch on back of the igniton. You can buy the switch seperately. You dont need the whole ignition assembly/switch only. Switch is pretty cheap (approx $50 ?). Try that and post results. I would feel pretty good about the switch beeing faulty. I have ssen them fail in the past and that's where your power comes into for the starter circuit.(key getting HOT, switch shorting out, making the key hot and starting the car without the key)
SOURCE: alarm wont shut off and I can't start vehicle
use the key and unlock the trunk...if that doesnt work do the passenger door...that should reset the alarm...
SOURCE: Need to turn the valet switch off On 1999 Nissan Maxima
Look for alarm Brain box and look for wires coming out black and red going to valet switch. to turn valet on turn ignition in ON position and press-switch or flip depending on the type of switch. If it a basic alarm just disconnect the main wiring harness to alarm box- unplug and the car should start. Good luck and thanks for using FIX YA
SOURCE: No tail lights, tag light, dash board lights in 97 Nissan Maxima
If you don't have a manual, just get a test light, and ground it to your door hinge. At the back of every fuse, you will see part of the metal filament showing through. Touch your test light to each side of the fuse. You should have power to both sides of every fuse (when your key is on). If no voltage on one side, the fuse is burnt.
SOURCE: My battery light indicator on dash board stays on
This is usually caused by a faulty alternator.
It stays on because the alternator is not generating sufficient voltage on the control winding to extinguish it.
Check battery terminal voltage while motor running with headlights on or blower fan running.
Terminal voltage should be approx 14.5V.
Ensure alternator and engine are properly connected to ground and the battery negative terminal.
218 views
Usually answered in minutes!
×