Need diagram for removing steering column for gmc 2500 three quarter ton truck 5.7 liter engine.
Remove two bolts under the dash the hold column to lower dash support, reach under and disconnect the wiring near bottom and then pull back the sound deadening and remove the bolts from the inner bulkhead, go under the hood and remove the rag joint coupler bolts, then remove the column from the truck with care to make sure you didn't miss any thing before you man handle it out like the shift indicator cable is so equipped..
SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4
click on this link, and scroll down to 5.7L
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e
SOURCE: 1998 Chevrolet S10 4X4 Pickup Truck 5 speed
No it is actually pretty simple
1) Disconnect battery
2)Remove shroud (cover behind steering wheel)
3)insert key and turn to start position while holding it in start position there will be a small hole in top of where the ignition goes into the column an depress retainer pin and pull out igntion
SOURCE: nned steerin column diagram
I don't have a diagram, But I have taken tons of these apart. Is there something I can help with?
SOURCE: wiring diagram for 1998 dodge ram 2500 pickup,
I have the wiring diagrams you need. Send me your email address and I will send them to you.
[email protected]
SOURCE: I need a wiring diagram for 1987 Chevrolet 3/4 ton
The Haynes repair manuals usuall have wiring diagrams in the back of book.Around $20.
849 views
Usually answered in minutes!
×