Pops and tries to die when i give it gas seems ok at idle but dies out when u try to pull out
SOURCE: engine overheated, now car won't start without giving it gas
Some cars cut off as a fail safe to overheating especially on newer cars. The computer controls the fans and if they are not working the computer is probably telling the car to shut off. Have you replaced the motors already, if not, this is what's happening. Once you replace the motors it should run fine. I wouldn't suggest driving it too much with this problem as it may affect the computer by giving it false info.
SOURCE: 2001 Dodge Caravan SE 2.4L.. In cold Weather it starts then stalls and dies...?
cable is fine,can be the tps but try tapping on the idle air valve and see if the idle kicks up,it works like a choke and if its stuck its a big vac leak
SOURCE: 2001 Dodge Caravan SE 2.4L.. In cold Weather it starts then stalls and dies...?
Inlet air temperature sensor, also known as throttle body temperature sensor, will do that. Don't go changing TPS, or IAC, as suggested in other post. If they work good in warm weather, they should do the same in cold. Air inlet sensor tells system how much fuel to deliver according to temperature, as engine needs more fuel the colder it is when starting.
SOURCE: dodge dakota wont idle
You might have a possibilty of a vacume leak check all vacume line connections.
Engine stalls cold or RPM
fluctuates at idle up and down or dies near idle.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.
Engine stalls or RPM
fluctuates at idle up and down or dies near idle.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
Engine stall or RPM fluctuates
at idle.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
Here is the common cause of surges, cold stalls, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours.
To correct this problem Buy a can of throttle valve cleaner (it is made by CRC) from the local auto parts store, NEVER USE CARB CLEANING SPRAY, IT DESTROYS THE ANTI-STICK TEFLON COATING, spray it into the air intake through the throttle body of the engine until you have used about half the can, you will need to hold the idle up while you do this, it will try to stall, after this shut the engine down and disconnect the Negative (-) battery cable for 5 minutes. The intake is now clean, if you continue to have the idle speed control problems you may need to seek the help of a professional.
149 views
Usually answered in minutes!
×