Question about Cars & Trucks

1 Answer

Overheating Runs for about 5 mins then overheats rapidly

Posted by cbaquinn on

Ad

1 Answer

raj somaiya

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,370 Answers

Overheating is caused by few possibilities .All needs to be checked inspected.I recommend you few help links to troubleshoot the issue.Click the link below:---

Car engine Overheats and transmission starts slipping?

http://schematicsdiagram.blogspot.com/2011/12/car-engine-overheats-and-transmission.html
---------

Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

---------
Engine overheated then car will not start?

http://schematicsdiagram.blogspot.in/2012/02/engine-overheated-then-car-will-not.html-----

All types of car overheating problems and troubleshooting?

http://technoanswers.blogspot.com/2011/11/all-types-of-car-overheating-problems.html
------------


Car freeze overnight and started overheating while driving? http://technoanswers.blogspot.com/2012/01/car-freeze-overnight-and-started.html


---------
Vehicle Is Overheating http://technoanswers.blogspot.in/2012/07/vehicle-is-overheating.html

---------
These will help.
Thanks.

Posted on Jul 21, 2012

Ad

2 Related Answers

Randy Ohler

  • 14585 Answers

SOURCE: Overheats. runs fine when idiling.holding

Water pump. The impeller will slip on the shaft. As you said runs fine at idle, but when you run it harder the impeller doesn't spin fast enough (slips). Causing it to over heat. replaced to many for this problem. Also The pumps that have the metal impellers will be tight when cold, don't let this fool you. when they heat up they slip.

Posted on Jul 20, 2011

Ad

Anonymous

  • 1 Answer

SOURCE: 2003 Protege 5 overheating on long runs.

I just replaced the radiator and thermostat on my 03. The radiator was defective (corroded) on the lip where the cap seals. This allowed coolant to be spat out. The thermostat was also sticking closed after new radiator and this caused overheating. Replace both while in there for under $100 if doing it yourself.

Posted on Mar 11, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have JD 935 that runs fine for 10 mins then idles down. Never fully quits running. Changed fuel filters, lines, pump...


check for the cooling fins around the head and block are not blocked with grass clippings/ dirt/dust as it may be tending to overheat and boiling off the fuel in the mixture

Sep 16, 2014 | Cars & Trucks

1 Answer

2001 Mazda MPV overheats. radiator hose doesnt feel pressurised ie very soft to squeeze. when i put coolant in after 5 mins of driving is backflows out of the reservoir and causes heavy smoking from t


sounds like the radiator is blocked either coolant flow or ext air flow through the matrix the thermostat can get ruined when the system overheats so allways change the stat after a overheat problem GET THE RAD CHECKED FIRST if ok check the coolant pump

Aug 22, 2017 | Mazda MPV Cars & Trucks

1 Answer

1993 Eagle Vision.. Car runs great... for 15 min. Then falls on its face..try to start..barley runs...rapidly pump gas pedal car will run barley. shakes and chokes and sputers... shut the car down for...


Could be fuel pump is going out. Its getting hot not working properly and when it cools down it works right again for a short period. Ive seen this happen several times.

Oct 05, 2013 | Eagle Vision Cars & Trucks

1 Answer

1994 f150 6 cyl engine shuts down every 10 min restart after 5 min


Sounds like the module inside the distributor. Have to be replaced.

Sep 29, 2012 | Cars & Trucks

1 Answer

Overheats. runs fine when idiling.holding the fan off, and a/c on still cant make it overheat but once driving for 5 mins starts to overheat. replaced thermostat, water pump looks to be fine. cleaned rad....


Water pump. The impeller will slip on the shaft. As you said runs fine at idle, but when you run it harder the impeller doesn't spin fast enough (slips). Causing it to over heat. replaced to many for this problem. Also The pumps that have the metal impellers will be tight when cold, don't let this fool you. when they heat up they slip.

Jul 20, 2011 | Mazda B-Series Truck Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

3,808 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23504 Answers

Brad Brown

Level 3 Expert

18519 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...