My lexus lx 470 suddenly enters neutral on drive and does not go into any shift mode
SOURCE: car occasional stalls at slow speeds
The problem may be inexpensive to fix but difficult to diagnose. My recommendation is to go to a garage and have it put on a machine to get a diagnosis. This will be money well spent as stalling at low speeds in traffic is dangerous.
SOURCE: How to Replace the AC filter on my Lexus 01 LX 470
Perform steps 1-3 first to inspect whether you have the access doors or not before ordering filters!!!
Did this little project this evening. Figured I'd write it up.
5 Easy steps:
1. Remove glove box door by removing both screws at the bottom of the door.
2. First pop the the little flap with a fuse/relay out of the black plastic shield in the upper portion of the glove box opening. Next push it back behind the shield through the opening. Next remove the 3 screws holding the shield in place. Don't pull this shield out yet!! Read step 3 first.
3. Gently pull the shield out. Be careful because the glove box light is still plugged into this part. It is located on the right side of the shield. Once it is pulled out slightly, unplug the bulb from the harness and now you can fully remove the part.
4. Now you can see the vertical cover where the air filters reside. The cover is about 5 inches tall and about 1 inch wide. It has 2 tabs on the upper portion of the cover. Squeeze these tabs towards each other and pull the cover off.
5. The filters are now exposed. They are stacked on top of each other. Pull the first filter out then lift the next filter up and pull out. Put new filters back in and reverse the procedure.
Parts needed:
2 Cabin air filters (Toyota PN 88568-60010 if you drop CDan a pm)
1 Phillips screw driver
Time needed:
No more than 15 minutes
STEP BY STEP PHOTO INSTRUCTIONS
Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FERE question.
SOURCE: Removing rear tail light in Lexus lx 470
Open the tailgate and then you must unsnap the carpeted part. It's easier with two people as the plastic part that says "Lexus" has to be pulled up out of the way as it will spring back in place if someone is not holding it. Don't be afraid to pull on the carpeted part; it will snap back with ease. When it's off you will see where the lights are. There are three screws you must undo so you can take off the metal cover. Should be pretty easy from there!
SOURCE: How to adjust Lexus LX 470 parking brake to hold
Pull the wheels off the back of the car. remove the rubber plug on the rotor hub and rotate the rotor to where the hole is on the bottom and look in there. you should be able to see a sprocket. take a long flathead screwdriver and move it up or down until the rotor does not freely move. then turn it two times in the opposite direction. do this for both sides then you should be good to go! good luck!
686 views
Usually answered in minutes!
×