I changed the bulbs and they still don't work. They do light when put in reverse.
That should be on two different fuses, but everything goes thru the turn signal switch.
The switch might be faulty. A mechanic would check for voltage there.
Hazard Warning Flasher known defect
SOURCE: Tail lights not working on 2000 ford focus
you have wires shorting out trace them to find out where
SOURCE: 2002 jeep grand cherokee. Rear left brake light isnt working
The problem with your tail light is the housing is broken where the socket goes in. If you pull that socket out and look you will see the metal tap will be pushed down and the plastic around that will be broke. Easy fix is to replace the lens but you can get under the metal tap with a small flat tip screw driver and pull up on it very lightly and it should work for awhile.
Hope this helps
Cory
SOURCE: 2001 dodge neon tail lights inop
looking at your schematics and , you say tail lights don't work , you didn't mention if front parking lights and license plate lights are working , they all come from the same source , a black /yellow wire , a good clue if front work and rear don't , please advise .if fronts work then you have a open circuit somewhere between junction S118 (near breakout for left headlamp) and rear sockets.
SOURCE: 1998 ford escort wagon brake lights out. bulbs and fuses changed.
have you tested the brake light switch? it is located at the top of the arm the brake pedal is attached to, it is very common for the wires to that switch to break inside the plastic insulation, the switch testing goes like this, there should be 12 volts present at both sides of the switch with the brake pedal depressed and one side without the pedal depressed.
SOURCE: 2005 jeep liberty brake lights will not work. I
brake pedal switch, get a wire, unplug plug, bridge circuit and check lights.
plug and switch is high up on the brake pedal not normally easy to get to.
558 views
Usually answered in minutes!
×