Truck runs good when first started but as soon it gets hot it stalls and shuts off and wont turn on
SOURCE: i have a 1999 nissan maxima with code P1320
This code is a crapshoot. There are two main things it could be and they are both expensive. There could be wire breakage in the engine harness. There is a thick harness coming out of engine bulkhead on the passenger/right side and it has a slight bend to it. With the engine idling grab that bend and give it a couple of twists and yanks. If the engine stumbles or misses that is the source of your troubles. If not, you more than likely need to replace the coils. Any one of the six coils could be causing the code so I recommend replacing all six at the same time. You could buy one coil for the front bank and one for the rear and swap it between cylinders to see which coil is causing the code. This is time consuming but cheaper.
SOURCE: 2001 nissan maxima gle crank no start code p1320...please help
Primary ignition fault. Reasons: Bad distributor cap (most likely) or ignition control module/ignition coil.
Hope that helps
Good Luck
SOURCE: 2006 Nissan Frontier Starter wont engage
Your starter solenoid is probably bad if the battery is good. Not sure if you can get just the solenoid or you have to buy the whole starte. Also check to make sure the cables are tight not only on the battery but the starter as well
SOURCE: where is the fuel filter 2005 nissan frontier?
Built in the gas tank. It is cleanable. Don't have to buy a new one.
It is built into the pump so if it would have to be replaced then you
would have to replace the whole pump. To me thats pretty crappy design.
Crawl under the truck, you should have two or three lines coming off the fuel tank, one will have the filter, one is the return, and one is emissions.
SOURCE: 2001 nissan sentra xe p1320, p1140 codes car
Distributer Signal Output is code p1320........Intake Valve Timing Control Position Sensor Bank1 is code p1140...
1,549 views
Usually answered in minutes!
×