2002 Chrysler Town and Country.
Wipers, turn signals, won't work, they are on the same switch. I could think that it would be my switch, but I have no tail lights, and the heater is taking a long time to heat. Is it my battery, I get a battery light then it goes off after about 5 minutes, but still no turn sig, wipers, or tail lights.
SOURCE: setting clock on the radio
using a ball point pen, pencil, etc. push in o the two dimples on the right hand side of the lcd display. one changes the hour, the other minutes.
SOURCE: 2002 Chrysler Town and Country
Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug
SOURCE: Transmission interchange
Yes the transmissions will interchange.You might have to use some of the sensors off the 2002 to put on the other.And Also the axles might have to be swaped to.But it will work.Good luck to you and have a great night...
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: radiator fan relay,2001 chrysler town country
the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays
SOURCE: front windshield wipers are crashing into each other
Yes you can adjust them yourself. First you need to check that the wiper arms are not bent. If not, remove the cap at the wiper arm base, under it u will find a nut, remove this nut. you should now be able to remove the wiper arm. (it is comon for caravan wiper arms to be corroded on. If the arm dosen't come off, you may need to heat up the wiper arm with a propane torch. be careful not to melt the plastic cowel under the arm. OR you can use a wiper puller or a battery puller. do not force it, you can break the arm, DO NOT PRY AGAINST THE COWEL OR WINDSHIELD.
Once both arms are off, turn your van on and turn the wipers on. watch the wiper posts, turn the wipers off and watch the wiper posts return and stop in the "parked" position. Turn the van off. Install the passanger wiper arm first, it is positioned closest to the bottom an inch or two above the black cowel. It should be parrallel to the cowel. next install the drivers side wiper arm. it is positioned about 4 inches above the passanger wiper. again running parrallel to the cowel and passanger wiper. tighten the lock nuts down (do not over tighten) wet down your windshield with glass cleaner or windshield washer fluid and test wipers. If they still hit you can lower the passanger one a little or raise the drivers one a little (careful you don't raise the drivers one too much or it will 'jump' off the windshield at the top of the wipe).
good luck, hope this helps.
Testimonial: "Thank you so much for the help!! My brother read your reply and fixed the wipers in no time. I am very appreciative of your help! Maryg :)"
121 views
Usually answered in minutes!
×