Car is jerking and seems like the accelerator is cutting out when reaching 3000-3200 rpms, I believe it is in the trans fail-safe mode.
P0500 (Vehicle Speed Sensor) May limit the revs of the motor & auto may shift erraticly. P0121 (Throttle Posision Sensor) I would start with this as it can also cause transmition probs. I would just look at these 2
SOURCE: Fail Safe Engine Mode
Sueaggie93....
Our 2006 Expedition (56K miles) is going in to safe mode and driving us nuts. How much did it cost to fix?
SOURCE: i have a 2000 dodge caravan 3.0L fault codes came
same thing happened in my dodge, come to find out it was the transmission module in the computer, computer needs changing out. I got the true reading from auto zone, transmission shop couldnt get right reading for a year and a half, try auto zone first, they can pinpoint your problem and its free, good luck
SOURCE: e300 1994 codes read p0720 and p0500 one is speed
try changing the drive shaft speed sensor, sounds like you have a malfunctioning drive shaft speed sensor, change sensor and reset codes and test... e 300 had this problem in 94 and 95 even when they were close to new with very low miles... please rate my help , thanks
SOURCE: etc fail safe mode codes p2104 2107 2110 2111 2112
P2104 Throttle Actuator Control System - Forced Idle
P2107 Throttle Actuator Control Module Processor
P2110 Throttle Actuator Control System - Forced Limited RPM
P2111 Throttle Actuator Control System - Stuck Open
P2112 Throttle Actuator Control System - Stuck Closed
Seems like Throttle Actuator is the problem.
Good luck on this repair.
481 views
Usually answered in minutes!
2001 Sante Fe 2.7L 6cyl AWD
×