Question about 1994 Dodge Caravan
Posted by Anonymous on
SOURCE: water pump
Is it a 99 or an 03? Either way fairly simple. You will need to remove the splash shield on the passenger side wheel well. Removing tire is optional. If it is a 99, the pump should be located near the radiator. Loosen the bolts that hold the pulley on the pump before removing the belt. This will save you time later. Remove the belt, then remove the pulley. Take all the bolts out of the waterpump. Install in reverse order. If it is an 03, it is near the firewall side of the motor. Remove shield, loosen pulley bolts. The pulley will not come off until you get the water pump out, but you need to remove the bolts for it any way. Take the bolts out of the waterpump. You will need a pry bar to get the pump/pulley out. You can pry on the tensioner against the fenderwell and wiggle it out. Install in reverse order.
Posted on Mar 06, 2009
1. is there gas in the tank?
2.is the pump getting power? SEE #4
3.why did you replace the pump? 4.some dodges need a scan tool to run the fuel pump to get the fuel system primed after replacing the pump. If the computer senses the engine isnt running after a few seconds it shuts the fuel system down. Happened on my friends jeep that was a chrysler system. Took a while to figure it out. The snap on red brick scan tool worked for this. Any scan tool(not just a code reader) that can get to functional tests of the engine computer will work.
Sounds like no fuel is getting past the pump,so get a scan tool capable of doing this,take hose off of fuel filter stick the end of the hose in something to catch the fuel that will come out and activate the pump. If fuel comes out the pump is working and the filter is clogged, if pump sounds like it is runnin and no fuel comming out pump is bad.If all is quiet pump isnt getting power.
Posted on Apr 24, 2009
you should be adding the 134a to the system the low pressure switch is doing its job by not allowing the compressor to kick on, it wont kick on until there is enough 134a in the system to be above the preset pressure for the low pressure switch.
Posted on Jun 27, 2009
Tips for a great answer:
May 29, 2018 | Dodge Cars & Trucks
Nov 11, 2016 | 1998 Dodge Grand Caravan
Aug 26, 2016 | 2003 Dodge Grand Caravan AWD
Nov 09, 2010 | 2003 Dodge Caravan
Sep 28, 2010 | Dodge Grand Caravan Cars & Trucks
Mar 09, 2010 | 2003 Pontiac Grand Am
Nov 07, 2009 | 2003 Dodge Grand Caravan AWD
Sep 30, 2009 | 2003 Dodge Caravan
Sep 12, 2009 | 1997 Dodge Grand Caravan
1,392 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: